This is an old revision of the document!
Paragon MARS / CAP / 60m Mod
From the Ten-Tec Reflector December 8, 2004
On my two Paragon's, the MARS/CAP/60M mod is accomplished by cutting/unsoldering the jumper wire on the logic board (Labeled "HAM") and resetting the processor. The jumper is located directly below the 9 volt memory battery.
NOW, if someone can tell me what/where the mod is on the Paragon II, I would appreciate it VERY much.
Jim/Ke3nK
December 9, 2004
Same place. Mine was a yellow wire loop labeled HAM and its about 1/3 from the back of the radio on the right side. Not sure what the board is, but it works well.
73 Rick
N4ASX