This is an old revision of the document!
Jupiter MARS / Out of Band Operation
From the Ten-Tec Reflector December 8, 2004
I believe TenTec has a firmware update for MARS operation. You might check with them.
When operating in Pegasus mode with computer control, there is a software command you can send to allow out of ham band operation.
#5<cr> enable transmit outside of ham bands
#4<cr> disable
<cr> is an ASCII carriage return.
Consult the Pegasus Programmer's Reference Guide (PRG) available from rfsquared.com. Note, that under the transmitter controls listing (on page 24), these commands are missing.
73,
Mark