Jupiter MARS / Out of Band Operation

From the Ten-Tec Reflector December 8, 2004

I believe TenTec has a firmware update for MARS operation. You might check with them.

When operating in Pegasus mode with computer control, there is a software command you can send to allow out of ham band operation.

#5<cr> enable transmit outside of ham bands
#4<cr> disable

<cr> is an ASCII carriage return.

Consult the Pegasus Programmer's Reference Guide (PRG) available from Ten-Tec.com. Note, that under the transmitter controls listing (on page 24), these commands are missing.


QR Code
QR Code 538mars (generated for current page)