Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
9420 [2007/02/11 23:16] n5na |
9420 [2015/05/19 11:33] (current) n1eu [General Description] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Power Supply Model 9420 ====== | ====== Power Supply Model 9420 ====== | ||
- | {{9420.jpg?150|}} For Hercules II Model 420 Amplifier | + | {{9420.jpg?150|}} For Hercules II Model [[420]] Amplifier |
+ | |||
+ | ===== General Description ===== | ||
+ | The Model 9420 Power Supply is designed primarily to power the Ten-Tec Model [[420]] Linear Amplifier. An auxiliary output will also power most HF transceivers including the Ten-Tec Models [[560]]/[[561]], [[562]], and [[585]]. The supply delivers a combined 100 amperes at 13.8 Vdc. Built-in voltage sensing turns off the supply if the output climbs above 16 Vdc and over current shut down, factory set to 25 Amperes, is included on the exciter output. | ||
+ | |||
+ | The supply is designed for "hands-off" operation and can be placed on the floor or in an otherwise out of the way location. | ||
+ | |||
+ | ===== Circuit Description ===== | ||
+ | //(posted to Ten-Tec reflector by Wade KJ4WS)// | ||
+ | |||
+ | It is basically Four independent power supplies in one | ||
+ | case. Pay close attention to the 4 pin power plug for the Ten Tec | ||
+ | Transceiver and the way that the 2 center pins turn the whole power supply | ||
+ | on and off. This is the same way the 960 is switched off and on with the | ||
+ | Corsair, Paragon and Omni Rigs. The only difference is that the Primary | ||
+ | Winding of the 960 is switched on and off and the 9420 uses a remote | ||
+ | voltage switching arrangement. | ||
===== Specifications ===== | ===== Specifications ===== |