Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
564 [2017/01/08 11:21] n1eu [Mods, Fixes, & Additional Info] |
564 [2022/08/08 16:33] n1eu [Related Links] |
||
---|---|---|---|
Line 16: | Line 16: | ||
===== Related Links ===== | ===== Related Links ===== | ||
- | *[[/webarchive/564|Archived Ten-Tec Web Page]] | + | *[[this>./webarchive/564|Archived Ten-Tec Web Page]] |
- | *[[/webarchive/filterhelp|Archived Ten-Tec Web Page - Filter Selection Help]] | + | *[[this>./webarchive/filterhelp|Archived Ten-Tec Web Page - Filter Selection Help]] |
*[[563upgrade|Option 1, 2, & 3 Upgrades - 563 / 564 Differences]] | *[[563upgrade|Option 1, 2, & 3 Upgrades - 563 / 564 Differences]] | ||
+ | *[[http://omni6.wikidot.com/start|Omni 6+ Wiki]] | ||
*[[http://lists.contesting.com/_tentec/2004-08/msg00926.html|Discussion Thread on v1.02 vs v1.03 firmware]] | *[[http://lists.contesting.com/_tentec/2004-08/msg00926.html|Discussion Thread on v1.02 vs v1.03 firmware]] | ||
- | **Looking Back at the Omni VI+**\\ | ||
- | {{youtube>small:c76_qv2WuDs}} | ||
Line 49: | Line 48: | ||
*[[564filters|Close-Up of Manual p3]] with filter installation info | *[[564filters|Close-Up of Manual p3]] with filter installation info | ||
*[[565lpf_remove|Removal of Low Pass Filter Board]] | *[[565lpf_remove|Removal of Low Pass Filter Board]] | ||
- | *[[http://omni6.wikidot.com/panadapt|Adding a 9MHz I.F. Output]] for use with a Panadapter | ||
*[[http://omni6.wikidot.com/amp|Mod to use Omni 6+ with non Ten-Tec QSK Amplifiers]] | *[[http://omni6.wikidot.com/amp|Mod to use Omni 6+ with non Ten-Tec QSK Amplifiers]] | ||
- | *[[http://n1eu.com/Mods/omni_keying.htm|Reducing Key Clicks in the Omni 6+]] | ||
*[[http://omni6.wikidot.com/kg5u-301|Homebrew 301 Remote Encoder]] by KG5U | *[[http://omni6.wikidot.com/kg5u-301|Homebrew 301 Remote Encoder]] by KG5U | ||
*[[http://omni6.wikidot.com/302r|Using 302R Remote Encoder with Omni 6]] | *[[http://omni6.wikidot.com/302r|Using 302R Remote Encoder with Omni 6]] | ||
Line 61: | Line 58: | ||
*[[564bias|Correction to Manual on Adjusting Transmit Bias]] | *[[564bias|Correction to Manual on Adjusting Transmit Bias]] | ||
*[[563calibrate|Using WWV to Calibrate]] | *[[563calibrate|Using WWV to Calibrate]] | ||
- | *[[http://n1eu.com/Mods/birdiesmod.htm|Eradicating Birdies from the Omni 6 (+)]] | ||
*[[http://omni6.wikidot.com/cw-keying|CW Keying Improvement]] | *[[http://omni6.wikidot.com/cw-keying|CW Keying Improvement]] | ||
*[[563keyer|Varying Keyer Speed Fix]] | *[[563keyer|Varying Keyer Speed Fix]] | ||
Line 67: | Line 63: | ||
*[[564clock|Setting the Clock]] | *[[564clock|Setting the Clock]] | ||
*[[564clock2|Clock Fix]] | *[[564clock2|Clock Fix]] | ||
+ | *[[564oven|Source for Omni VI/VI+ Crystal Oven]] | ||
*[[564tcxo|TCXO Information]] | *[[564tcxo|TCXO Information]] | ||
*[[563inrad|Inrad Roofing Filter Mod - Switchable In/Out]] | *[[563inrad|Inrad Roofing Filter Mod - Switchable In/Out]] | ||
- | *[[http://omni6.wikidot.com/rxaudio|Improving SSB and CW RX Audio]] | ||
*[[564intermvfo|Intermittent VFO Possible Fix]] | *[[564intermvfo|Intermittent VFO Possible Fix]] | ||
*[[564erratic|Erratic RX Fix]] | *[[564erratic|Erratic RX Fix]] | ||
Line 84: | Line 80: | ||
*[[http://pa0fri.home.xs4all.nl/Mods/OMNI%20VI/Omni%20VI%20modseng.htm|PA0FRI Omni VI Mod Page]] | *[[http://pa0fri.home.xs4all.nl/Mods/OMNI%20VI/Omni%20VI%20modseng.htm|PA0FRI Omni VI Mod Page]] | ||
*Logic Board connectors 34/41 - conn plug 34 is displaced toward connector 41 leaving the extra (open) header pin toward the rear | *Logic Board connectors 34/41 - conn plug 34 is displaced toward connector 41 leaving the extra (open) header pin toward the rear | ||
+ | *{{wiring_diagram_model_563-564.pdf|Model 563/564 Wiring Diagram by 4Z5UN}} | ||
===== Sales Information ===== | ===== Sales Information ===== | ||
{{564brochure.pdf|Omni VI+ Sales Brochure}} | {{564brochure.pdf|Omni VI+ Sales Brochure}} | ||
Line 93: | Line 90: | ||
***Modes:** USB, LSB, FSK or AFSK, FM | ***Modes:** USB, LSB, FSK or AFSK, FM | ||
***Frequency Range:** All ham bands 160 through 10 meters. Twelve 500 KHz segments with 30 KHz overshoot at upper and lower band edges. | ***Frequency Range:** All ham bands 160 through 10 meters. Twelve 500 KHz segments with 30 KHz overshoot at upper and lower band edges. | ||
- | ***Display:** 7 digit to 10 Hz resolution, 0.56" LED, 2 secondary 0.3" displays for clock, memory chanhel and offset. | + | ***Display:** 7 digit to 10 Hz resolution, 0.56" LED, 2 secondary 0.3" displays for clock, memory channel and offset. |
***Frequency Control:** LO generated with a crystal oscillator mixed with a low noise 4.97 - 5.53 MHz phase locked loop. | ***Frequency Control:** LO generated with a crystal oscillator mixed with a low noise 4.97 - 5.53 MHz phase locked loop. | ||
***Dual VFO's** with SPLIT mode. | ***Dual VFO's** with SPLIT mode. | ||
Line 103: | Line 100: | ||
***Remote Band Switching:** Selects antenna or other station accessories. | ***Remote Band Switching:** Selects antenna or other station accessories. | ||
***Power Required:** 2 A receive, 20 A transmit @ 12-15 VDC. | ***Power Required:** 2 A receive, 20 A transmit @ 12-15 VDC. | ||
- | ***Construction:** 20 epoxy glass PC boards, most field replaceable. Extruded aluminum front panel, alumninum chassis, texture painted top & bottom, snap up stainless stell bail. | + | ***Construction:** 20 epoxy glass PC boards, most field replaceable. Extruded aluminum front panel, aluminum chassis, texture painted top & bottom, snap up stainless steel bail. |
***Dimensions:** HWD 5.75" x 14.75" x 17" - 14.6 x 37.5 x 43.2 cm. | ***Dimensions:** HWD 5.75" x 14.75" x 17" - 14.6 x 37.5 x 43.2 cm. | ||
***Weight:** 16 lbs - 7.25 kg. | ***Weight:** 16 lbs - 7.25 kg. |