Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
564txenout [2011/11/15 13:17] n1eu |
564txenout [2011/11/15 13:21] n1eu |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| - | Although the Omni 6+ can be used with the Acom 2000A by enabling the relay in the menu and using the relay output, it's preferable to perform a simple mod to allow the TX EN/OUT qsk loop to fully function. | + | Although the Omni 6+ can be used with the Acom 2000A by enabling the relay in the menu and using the relay output, it's preferable to perform a simple mod to the Omni 6 Control Board that allows the TX EN/OUT qsk loop to fully function. Remove the Control Board from the chassis, unsolder/lift one end of R26 as shown, and add the circuitry in blue below. The MOSFET is available from Digikey as part number VN10LP-ND |
| {{:txenoutmod.jpg?|}} | {{:txenoutmod.jpg?|}} | ||
