Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
orionfw [2015/05/02 09:58] n1eu |
orionfw [2018/10/28 22:42] n5na [05/27/03 Version 1.343] |
||
|---|---|---|---|
| Line 82: | Line 82: | ||
| ==== 05/19/03-05/22/03 Version 1.342 ==== | ==== 05/19/03-05/22/03 Version 1.342 ==== | ||
| - | **[[/firmware/565v1342.zip|Download 1.342]]** | + | **[[https://tentecwiki.eqth.net/firmware/565v1342.zip|Download 1.342]]** |
| *Fixed placement of Side Tone Frequency in the CW MENU. | *Fixed placement of Side Tone Frequency in the CW MENU. | ||
| *Removed LCD CONTRAST from storage in USER profiles. Now a Global Value. | *Removed LCD CONTRAST from storage in USER profiles. Now a Global Value. | ||
| Line 91: | Line 91: | ||
| ==== 05/27/03 Version 1.343 ==== | ==== 05/27/03 Version 1.343 ==== | ||
| - | **[[/firmware/565v1343.zip|Download 1.343]]** | + | **[[https://tentecwiki.eqth.net/firmware/565v1343.zip|Download 1.343]]** |
| *Added restore of pre-amp setting on power cycle. | *Added restore of pre-amp setting on power cycle. | ||
| *ATTN/NR/AN/SQL and Speech Processor now restored correctly on power-up. | *ATTN/NR/AN/SQL and Speech Processor now restored correctly on power-up. | ||
| Line 504: | Line 504: | ||
| * S-meter is calibrated so S-9 is 50 uV across 50 Ohms at the antenna terminals. | * S-meter is calibrated so S-9 is 50 uV across 50 Ohms at the antenna terminals. | ||
| * S-meter calibration routine updated to correct for a missing step in the table. | * S-meter calibration routine updated to correct for a missing step in the table. | ||
| + | * S-meter ballistics follow the Hang Time and Decay Rate of currently selected AGC profile. | ||
| * Serial Commands to change either VFO frequency were restored to previous functionality by removing the band checking. Note that a serial command setting the Main Rx VFO outside of a ham band may cause the VFO knob to not change frequency. | * Serial Commands to change either VFO frequency were restored to previous functionality by removing the band checking. Note that a serial command setting the Main Rx VFO outside of a ham band may cause the VFO knob to not change frequency. | ||
