Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
omniagc [2024/02/10 17:48] n5na |
omniagc [2024/02/10 17:49] n5na |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| Steve\\ | Steve\\ | ||
| N4LQ | N4LQ | ||
| - | + | \\ | |
| + | \\ | ||
| **Alternative AGC Pop Solution for Ten-Tec Omni D by Steve, KA0SM** | **Alternative AGC Pop Solution for Ten-Tec Omni D by Steve, KA0SM** | ||
| Line 36: | Line 36: | ||
| The output from the IF-AGC board is nominally around 0.1 to 0.2V RMS, so installing diodes has no effect to the signal under normal conditions. The diodes only conduct when the signal exceeds their forward bias voltage. | The output from the IF-AGC board is nominally around 0.1 to 0.2V RMS, so installing diodes has no effect to the signal under normal conditions. The diodes only conduct when the signal exceeds their forward bias voltage. | ||
| - | 73, | + | Steve\\ |
| - | + | KA0SM | |
| - | Steve - KA0SM | + | |
