Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
960 [2007/09/27 21:08] n5na created |
960 [2007/09/27 21:21] n5na |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Power Supply / Speaker Model 960 ====== | ====== Power Supply / Speaker Model 960 ====== | ||
| + | {{960.jpg?150}} | ||
| + | ===== Description ===== | ||
| + | The Model 960 Power Supply is designed to power the Ten-Tec models [[560]]/[[561]] and [[585]] transceivers. The supply delivers 20 Amps at 13.5 Vdc from a 115/230 Vac 50-60 Hz source. Circuit features include an electronic over-current sensor which shuts off the output if the current demand exceeds 22 amps. The over-current shut down condition is reset by cycling the POWER switch from ON to OFF and back to ON. Output over-voltage protection is also included to prevent the output voltage from exceeding 16.0 Vdc. | ||
| + | |||
| + | The output voltage is available through a heavy duty 3 foot cable and connector. the cable carries +13.5 Vdc, ground and the "hot" side of the ac primary and mates directly to the POWER jack on the [[560]]/[[561]] and [[585]] transceivers. Two RCA phono jacks on the back of the supply also provide +13.5 Vdc for low current (2 or 3 amps) auxiliary applications. | ||
| + | |||
| + | ===== Specifications ===== | ||
| + | ***Input Voltage:** 109 - 125 Vac or 218 - 250 Vac, 50-60 Hz. | ||
| + | ***Output Voltage:** 13.8 Vdc, internally adjustable from 11.5 to 15.0 Vdc. | ||
| + | ***Output Current:** 20 Amps full load, 22 Amps maximum for 5 minutes. | ||
| + | ***Current Limiting:** Electronically disables output. Factory set threshold at 22 Amps. | ||
| + | ***Regulation:** -3% at output connector for no load to 20 A full load. | ||
| + | ***Ripple:** 20 mV peak to peak at 20 A. | ||
| + | ***Speaker Impedance:** 8 ohms | ||
