Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
599 [2010/11/19 23:54]
k0mu added link to yahoo group 		599 [2010/11/25 18:14]
n5na
Line 10: Line 10:
   *[[http://​groups.yahoo.com/​group/​TenTec_Eagle/​|Eagle Yahoo Group]]   *[[http://​groups.yahoo.com/​group/​TenTec_Eagle/​|Eagle Yahoo Group]]
  
 +===== Specifications =====
 +
 +==== General ====
 +
 +Microphone Connector: 8-Pin
 +
 +Headphone Jack: 1/4" Stereo, accepts mono or stereo plug.
 +
 +External CW Key Jack: 1/8 " Stereo
 +
 +External Speaker Jack: 1/8" Mono
 +
 +Aux DC Output Connector: RCA x2
 +
 +Frequency Range TX: Ham Bands Only (160-6M)
 +
 +ACC Din Connector: 8 PIN DIN Connector - Line In, Line Out, Aux PTT, Ext Key, Clock/​Data/​Enable,​ Ground
 +
 +DC Power Connector: Power Pole
 +
 +Fuse: Automotive Blade Style Fuse, 25 Amp 32V
 +
 +Frequency Range RX: 500 kHz � 30 MHz and 50 � 54MHz. Specifications apply within Amateur Radio bands only.
 +
 +Tuning Step Size: 1, 10, 100, 1000, 10000
 +
 +Frequency Stability: Maximum +/- 0.5 PPM over operating temperature
 +
 +Antenna Impedance: 50 ohms nominal.
 +
 +Antenna Connectors: 1 x SO-239 transceive
 +
 +Modes: USB, LSB, CW, AM (optional), FM (optional)
 +
 +Memories: 100
 +
 +Frequency Accuracy: +-5Hz @25C, 1 Hz tuning resolution
 +
 +Supply Voltage Range: 13.8V +/-15%
 +
 +Operating Temp. Range: 0-50 degrees Celsius
 +
 +Dimensions (HxWxD): 2.9" x 8.5" x 10.25" (excluding knobs and connectors)
 +
 +Weight: 7.25 lbs with all options
 +
 +Construction:​ Molded plastic front panel, aluminum chassis and texture painted steel covers
 +
 +PC Control Port: USB (using CCS USB to UART Driver)
 +
 +Display: Custom FSTN monochrome LCD
 +
 +Display Backlight: 256 colors X 16 intensity levels
 +
 +==== Receiver ====
 +
 +SSB Sensitivity:​ Better than 0.7uV, 2.4khz, 10dB SINAD, preamp off
 +
 +AM Sensitivity:​ Better than 4uV, 30% Mod, 6kHz BW, 10dB SINAD, preamp off
 +
 +FM Sensitivity:​ Better than 2.2uV, 5kHz Dev, 16kHz BW, 10dB SINAD, preamp off
 +
 +Selectivity IF1: 2.4khz standard, 9.0015 MHz, 2 options
 +
 +Selectivity IF2: 30 KHz Lowpass filter
 +
 +Selectivity,​ DSP IF: 127 built-in DSP filters from 100-15000 Hz BW
 +
 +Third Order Intercept Point (IP3): Typical 20dBm @ 20kHz tone separation/​2.4 kHz roofing filter, 17dBm @ 2kHz separation/​600Hz roofing filter, S5 method, preamp off
 +
 +IMD3 Dynamic Range: Typical 97dB/20kHz, 95dB/2kHz, 500Hz BW, calculated 2/​3(IP3-Noise Floor), preamp off
 +
 +Blocking Dynamic Range: 138dB/​20kHz,​ 127dB/2kHz, 500 Hz BW, RF gain @ 12 o'​clock,​ preamp off
 +
 +LO Phase Noise: Typical -132dBc/Hz @ 20kHz, -121dBc/Hz @ 2kHz
 +
 +Noise Floor: Typical -132dBm/​500Hz BW/preamp on, -126dBm preamp off
 +
 +IF Frequencies:​ 1st:9.0015 MHz, 2nd:22.5 kHz, 3rd:0Hz (DSP)
 +
 +IF Rejection: Better than 70dB
 +
 +1st IF Image Rejection: Better than 90dB/HF bands, 70dB/6M
 +
 +2nd IF Image Rejection: Better than 73dB
 +
 +Other Spurious Response Rejection: Rejection:>​80dB
 +
 +Other Spurious Response Rejection: Birdies: Typically less than -100dBm equivalent (no more than 5 birdies greater than -100dBm equivalent)
 +
 +Pass Band Tuning: +/- 2.1kHz, 5Hz steps. Small dead zone for centering
 +
 +Attenuator: 10 db
 +
 +PreAmp: Nominal 12 db
 +
 +Audio Output: 2W into 4 ohms, <3% THD
 +
 +RIT range: +/- 8.2 kHz
 +
 +RIT Step size: 10Hz
 +
 +S-Meter Reference: S9 = 50 uV RMS
 +
 +TX>RX Recovery Time: < 20 ms
 +
 +RX Headphone Output: Designed for 16-32 ohms impedance headphones. Usable at 8 ohms
 +
 +AUX Audio Output: 500 mv
 +
 +Auto Notch: IF DSP, multi-tone
 +
 +RX Noise Reduction: IF DSP, adjustable
 +
 +Noise Blanker: Optional daughter board, 2 levels of blanking
 +
 +RX Current Drain: 1.25 Amps
 +
 +General Coverage Receive: degraded specs outside ham bands
 +
 +==== Transmitter ====
 +
 +RF Power Output: Adjustable, 5-100 W, +/- 1 dB
 +
 +CW & SSB Duty Cycle: continuous service @ 100W
 +
 +AM,​FM,​AFSK,​PSK Duty Cycle: continuous service @100W, 50% duty cycle (Tx/Rx)
 +
 +CW/SSB TX Bandwidth:
 +2.4kHz Filter
 +
 +AM TX Bandwidth: 6k
 +
 +FM TX Bandwidth: 15kHz Optional Filter
 +
 +Microphone Input Impedance:>​10 k-ohms at 1 kHz
 +
 +Microphone Sensitivity:​ 1 mV RMS for full power output, internal gain adjustment, 9v dc power for electret elements
 +
 +FM Deviation: +/- 5 kHz peak nominal
 +
 +AUX Level Input: variable, 200mV nominal
 +
 +SSB Carrier Supression:>​ 70 dB
 +
 +Unwanted Sideband Suppression:>​ 60 dB at 1 kHz
 +
 +Harmonic & Spurious Outputs: <-50dBc @100 W <30MHz; -60dB>​30MHz;​ -43 dB <5 W
 +
 +T/R Switching: PTT or VOX on SSB, AM, FM, QSK on CW
 +
 +CW Keyer Type: Internal Curtis Mode B
 +
 +CW Rise and Fall Times: 5ms
 +
 +CW Offset: adjustable
 +
 +CW Keyer Speed: 5-60 WPM, adjustable weighting
 +
 +Current Drain: transmit 20 amps typ.
 +
 +Third Order Intermod: Better than 25dB below peak
 +
 +SSB Generation: DSP Generated
 +
 +# of DSP generated TX bandwidths: 3 built-in DSP filters - automatically selected - standard = 2.4Khz for SSB/CW; optional = 6Khz for AM, 12Khz for FM
 +
 +==== Antenna Tuner ====
 +
 +Type: Reversible L-network
 +
 +Matching frequency range: 160 to 10 Meters, no Six Meters
 +
 +Matching impedance range: 10:1 SWR typical
 +
 +==== Ooptions ====
 +
 +Filters: 2.4K standard, optional = 300, 600, 1.8k, 6k, 15k
 +
 +Noise Blanker: daughter board module
 +
 +Auto Tuner: daughter board module

Trace:

QR Code
QR Code 599 (generated for current page)