Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
599 [2010/11/10 22:49]
n5na
599 [2010/11/25 18:24]
n5na [Receiver]
Line 2: Line 2:
 {{599.jpg?​200|}}{{599rear.jpg?​250|Eagle Rear}} {{599.jpg?​200|}}{{599rear.jpg?​250|Eagle Rear}}
  
-This is a current production model. ​ Please visit [[http://​www.tentec.com/​index.php?​id=2|Ten-Tec, Inc.]] for more information.+This is a current production model. ​ Please visit [[http://​www.tentec.com/​index.php?​id=360|Ten-Tec, Inc.]] for more information.
  
 ===== Description ===== ===== Description =====
 HF plus 6 meters transceiver along with general coverage receive. Dual VFO’s with SPLIT mode and 100 memories, passband tuning, adjustable AGC, variable CW offset, RIT, built in CTCSS tones for 6 meter FM and QSK. HF plus 6 meters transceiver along with general coverage receive. Dual VFO’s with SPLIT mode and 100 memories, passband tuning, adjustable AGC, variable CW offset, RIT, built in CTCSS tones for 6 meter FM and QSK.
  
 +===== Related Links =====
 +  *[[http://​groups.yahoo.com/​group/​TenTec_Eagle/​|Eagle Yahoo Group]]
 +
 +===== Specifications =====
 +
 +==== General ====
 +
 +  ***Microphone Connector:​** 8-Pin
 +  ***Headphone Jack:** 1/4" Stereo, accepts mono or stereo plug.
 +  ***External CW Key Jack:** 1/8 " Stereo
 +  ***External Speaker Jack:** 1/8" Mono
 +  ***Aux DC Output Connector:​** RCA x 2
 +  ***Frequency Range TX:** Ham Bands Only (160-6M)
 +  ***ACC Din Connector:​** 8 PIN DIN Connector - Line In, Line Out, Aux PTT, Ext Key, Clock/​Data/​Enable,​ Ground
 +  ***DC Power Connector:​** Power Pole
 +  ***Fuse:** Automotive Blade Style Fuse, 25 Amp 32V
 +  ***Frequency Range RX:** 500 kHz - 30 MHz and 50 - 54MHz. Specifications apply within Amateur Radio bands only.
 +  ***Tuning Step Size:** 1, 10, 100, 1000, 10000
 +  ***Frequency Stability:​** Maximum +/- 0.5 PPM over operating temperature
 +  ***Antenna Impedance:​** 50 ohms nominal.
 +  ***Antenna Connectors:​** 1 x SO-239 transceive
 +  ***Modes:** USB, LSB, CW, AM (optional), FM (optional)
 +  ***Memories:​** 100
 +  ***Frequency Accuracy:** +-5Hz @25C, 1 Hz tuning resolution
 +  ***Supply Voltage Range:** 13.8V +/-15%
 +  ***Operating Temp. Range:** 0-50 degrees Celsius
 +  ***Dimensions (H x W x D):** 2.9" x 8.5" x 10.25" (excluding knobs and connectors)
 +  ***Weight:​** 7.25 lbs with all options
 +  ***Construction:​** Molded plastic front panel, aluminum chassis and texture painted steel covers
 +  ***PC Control Port:** USB (using CCS USB to UART Driver)
 +  ***Display:​** Custom FSTN monochrome LCD
 +  ***Display Backlight:​** 256 colors X 16 intensity levels
 +
 +==== Receiver ====
 +
 +  ***SSB Sensitivity:​** Better than 0.7uV, 2.4khz, 10dB SINAD, preamp off
 +  ***AM Sensitivity:​** Better than 4uV, 30% Mod, 6kHz BW, 10dB SINAD, preamp off
 +  ***FM Sensitivity:​** Better than 2.2uV, 5kHz Dev, 16kHz BW, 10dB SINAD, preamp off
 +  ***Selectivity IF1:** 2.4khz standard, 9.0015 MHz, 2 options
 +  ***Selectivity IF2:** 30 KHz Lowpass filter
 +  ***Selectivity,​ DSP IF:** 127 built-in DSP filters from 100-15000 Hz BW
 +  ***Third Order Intercept Point (IP3):** Typical 20dBm @ 20kHz tone separation/​2.4 kHz roofing filter, 17dBm @ 2kHz separation/​600Hz roofing filter, S5 method, preamp off
 +  ***IMD3 Dynamic Range:** Typical 97dB/20kHz, 95dB/2kHz, 500Hz BW, calculated 2/​3(IP3-Noise Floor), preamp off
 +  ***Blocking Dynamic Range:** 138dB/​20kHz,​ 127dB/2kHz, 500 Hz BW, RF gain @ 12 o'​clock,​ preamp off
 +  ***LO Phase Noise:** Typical -132dBc/Hz @ 20kHz, -121dBc/Hz @ 2kHz
 +  ***Noise Floor:** Typical -132dBm/​500Hz BW/preamp on, -126dBm preamp off
 +  ***IF Frequencies:​** 1st:9.0015 MHz, 2nd:22.5 kHz, 3rd:0Hz (DSP)
 +  ***IF Rejection:​** Better than 70dB
 +  ***1st IF Image Rejection:​** Better than 90dB/HF bands, 70dB/6M
 +  ***2nd IF Image Rejection:​** Better than 73dB
 +  ***Other Spurious Response Rejection:​** Rejection:>​80dB
 +  ***Other Spurious Response Rejection:​** Birdies: Typically less than -100dBm equivalent (no more than 5 birdies greater than -100dBm equivalent)
 +  ***Pass Band Tuning:** +/- 2.1kHz, 5Hz steps. Small dead zone for centering
 +  ***Attenuator:​** 10 db
 +  ***Preamp:​** Nominal 12 db
 +  ***Audio Output:** 2W into 4 ohms, <3% THD
 +  ***RIT range:** +/- 8.2 kHz
 +  ***RIT Step size:** 10Hz
 +  ***S-Meter Reference:​** S9 = 50 uV RMS
 +  ***TX>RX Recovery Time:** < 20 ms
 +  ***RX Headphone Output:** Designed for 16-32 ohms impedance headphones. Usable at 8 ohms
 +  ***AUX Audio Output:** 500 mv
 +  ***Auto Notch:** IF DSP, multi-tone
 +  ***RX Noise Reduction:​** IF DSP, adjustable
 +  ***Noise Blanker:** Optional daughter board, 2 levels of blanking
 +  ***RX Current Drain:** 1.25 Amps
 +  ***General Coverage Receive:** degraded specs outside ham bands
 +
 +==== Transmitter ====
 +
 +  ***RF Power Output:** Adjustable, 5-100 W, +/- 1 dB
 +  ***CW & SSB Duty Cycle:** continuous service @ 100W
 +  ***AM,​FM,​AFSK,​PSK Duty Cycle:** continuous service @100W, 50% duty cycle (Tx/Rx)
 +  ***CW/SSB TX Bandwidth:​** 2.4kHz Filter
 +  ***AM TX Bandwidth:​** 6k
 +  ***FM TX Bandwidth:​** 15kHz Optional Filter
 +  ***Microphone Input Impedance:​** >10 k-ohms at 1 kHz
 +  ***Microphone Sensitivity:​** 1 mV RMS for full power output, internal gain adjustment, 9v dc power for electret elements
 +  ***FM Deviation:​** +/- 5 kHz peak nominal
 +  ***AUX Level Input:** variable, 200mV nominal
 +  ***SSB Carrier Supression:​** > 70 dB
 +  ***Unwanted Sideband Suppression:​** > 60 dB at 1 kHz
 +  ***Harmonic & Spurious Outputs:** <-50dBc @100 W <30MHz; -60dB>​30MHz;​ -43 dB <5 W
 +  ***T/R Switching:​** PTT or VOX on SSB, AM, FM, QSK on CW
 +  ***CW Keyer Type:** Internal Curtis Mode B
 +  ***CW Rise and Fall Times:** 5ms
 +  ***CW Offset:** adjustable
 +  ***CW Keyer Speed:** 5-60 WPM, adjustable weighting
 +  ***Current Drain:** transmit 20 amps typ.
 +  ***Third Order Intermod:** Better than 25dB below peak
 +  ***SSB Generation:​** DSP Generated
 +  ***No. of DSP generated TX bandwidths:​** 3 built-in DSP filters - automatically selected - standard = 2.4Khz for SSB/CW; optional = 6Khz for AM, 12Khz for FM
 +
 +==== Antenna Tuner ====
 +
 +  ***Type:** Reversible L-network
 +  ***Matching frequency range:** 160 to 10 Meters, no Six Meters
 +  ***Matching impedance range:** 10:1 SWR typical
 +
 +==== Options ====
 +
 +  ***Filters:​** 2.4K standard, optional = 300, 600, 1.8k, 6k, 15k
 +  ***Noise Blanker:** daughter board module
 +  ***Auto Tuner:** daughter board module

QR Code
QR Code 599 (generated for current page)