Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
588firmware [2018/10/31 17:57] n5na |
588firmware [2018/10/31 18:00] n5na [Version 1.036] |
||
|---|---|---|---|
| Line 271: | Line 271: | ||
| *Changes that affect both Remote Mode and Radio Modes: | *Changes that affect both Remote Mode and Radio Modes: | ||
| *Improve transmit audio performance in FM mode. | *Improve transmit audio performance in FM mode. | ||
| - | ***Changes that affect Remote Mode only:** | + | **Changes that affect Remote Mode only:** |
| *Increased Ethernet Handling priority in Remote Mode. | *Increased Ethernet Handling priority in Remote Mode. | ||
| *Modified the Remote Mode displayed FAIL counter to include | *Modified the Remote Mode displayed FAIL counter to include | ||
| Line 319: | Line 319: | ||
| *Increased priority of Ethernet audio packet handling. Preserving DSP functioning within allotted time. (e.g. AN, NR, etc. all still worked at least as well as version 1.035.) | *Increased priority of Ethernet audio packet handling. Preserving DSP functioning within allotted time. (e.g. AN, NR, etc. all still worked at least as well as version 1.035.) | ||
| *Improved handling of QRN/impulse type noise so it wouldn't prematurely load up AGC. | *Improved handling of QRN/impulse type noise so it wouldn't prematurely load up AGC. | ||
| - | *Added Bandwidth to the rig memory recall/restore. This was added so that customers could store settings for digital modes using sideband as the mode but wanting a narrower bw filter. ***Caveat, when going from 1.035 to 1.036, when one does a recall, the BW will get recalled as 12kc, simply adjust the bw to the desired value, and then re-save the VFO to Memory. From then on the bandwidth for that specific memory will get recalled properly. This should be done for all memories the user has already stored. | + | *Added Bandwidth to the rig memory recall/restore. This was added so that customers could store settings for digital modes using sideband as the mode but wanting a narrower bw filter. **Caveat, when going from 1.035 to 1.036, when one does a recall, the BW will get recalled as 12kc, simply adjust the bw to the desired value, and then re-save the VFO to Memory. From then on the bandwidth for that specific memory will get recalled properly. This should be done for all memories the user has already stored.** |
| *Added Memory Recall (*Rnn, nn=0..99) to the CAT interface | *Added Memory Recall (*Rnn, nn=0..99) to the CAT interface | ||
| *Added Memory Write (*Snn, nn=0..99) to the CAT interface | *Added Memory Write (*Snn, nn=0..99) to the CAT interface | ||
