Differences
This shows you the differences between two versions of the page.
586audiobp [2007/04/18 18:08] n5na created |
586audiobp [2007/04/18 18:10] n5na |
||
---|---|---|---|
Line 12: | Line 12: | ||
73\\ | 73\\ | ||
Steve N4LQ | Steve N4LQ | ||
+ | |||
+ | ---- | ||
+ | **December 20, 2004** | ||
+ | |||
+ | I would like to thank Steve for posting this information concerning incorrect component values in the Paragon II audio filter circuit. Minutes after I received this e-mail last night, I checked the IF/audio board in my Paragon II, and while I found that R65 was the correct value, R64 was not. | ||
+ | |||
+ | The Paragon II schematic shows that R64 is supposed to be 10K (as Steve mentions), but my audio board had a 33K. The difference in audio filter performance when R64 is changed from 33K to 10K is striking, and the filter is now a true asset to the CW performance of the radio. | ||
+ | |||
+ | My biggest complaint regarding the documentation for the Paragon II is that unlike the Paragon I, the manual does not include a component-layout drawing (at least this is the case with the Oct, 1993 manual I have). So to do something as simple as checking these resistor values, you have to remove the board, guess which IC is which, start counting IC pins and match the schematic to the board. Checking all the resistor values in the audio filter section took some time as it was necessary to flip the board over | ||
+ | many times to see what traces go where, and what part is tied to each trace. | ||
+ | |||
+ | Scott\\ | ||
+ | N7NB |