Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
564txenout [2011/11/20 12:07] n1eu |
564txenout [2011/11/20 12:20] n1eu |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| **UPDATE:** I implemented the change below and I am still getting "Detected RF Power at Wrong Time" errors in SSB about 10% of the time (not CW). I tried all methods of connecting the Omni 6+ to the Acom 2000A and couldn't get around these occasional errors during SSB xmsn. I am waiting for a solution from Acom, but I'm not sure if the Acom and Omni 6+ is a good match. My Omni 6+ runs fine with my Alpha 99. | **UPDATE:** I implemented the change below and I am still getting "Detected RF Power at Wrong Time" errors in SSB about 10% of the time (not CW). I tried all methods of connecting the Omni 6+ to the Acom 2000A and couldn't get around these occasional errors during SSB xmsn. I am waiting for a solution from Acom, but I'm not sure if the Acom and Omni 6+ is a good match. My Omni 6+ runs fine with my Alpha 99. | ||
| + | ---- | ||
| Although the Omni 6+ can be used with the Acom 2000A by enabling the relay in the menu and using the relay output, it's preferable to perform a simple mod to the Omni 6 Control Board that allows the TX EN/OUT qsk loop to fully function. Remove the Control Board from the chassis, unsolder/lift one end of R26 as shown, and add the circuitry in blue below. The MOSFET is available from Digikey as part number VN10LP-ND | Although the Omni 6+ can be used with the Acom 2000A by enabling the relay in the menu and using the relay output, it's preferable to perform a simple mod to the Omni 6 Control Board that allows the TX EN/OUT qsk loop to fully function. Remove the Control Board from the chassis, unsolder/lift one end of R26 as shown, and add the circuitry in blue below. The MOSFET is available from Digikey as part number VN10LP-ND | ||
| Line 8: | Line 9: | ||
| {{:txenoutmod.jpg?|}} | {{:txenoutmod.jpg?|}} | ||
| - | //(based on info provided by Acom Bulgaria for the Paragon and adapted for Omni 6 by N1EU - Q14 and Q15 numbering was reversed in the Paragon)// | + | //(based on info provided by Acom Bulgaria for the Paragon and adapted for Omni 6 by N1EU - Q14 and Q15 numbering was reversed and R20 was R22 in the Paragon)// |
