Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
251 [2007/02/14 22:39] n5na |
251 [2007/10/06 18:53] (current) n5na |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Power Supply Model 251 ====== | ====== Power Supply Model 251 ====== | ||
| - | {{251.jpg?150|}} | + | {{251.jpg?150|}}{{251rear.jpg?135|}} |
| ===== Description ===== | ===== Description ===== | ||
| - | *Delivers up to 100 watts DC power from either 115 or 230 VAC, 50-60 Hz. | + | The Model 251 Power Supply will deliver up to 9 amperes at approximately 13 VDC, regulated, from a 117 VAC 50-60 Hz source. An electronic latching circuit breaker shuts down the output voltage when a current in excess of 10 amperes is drawn from the supply. Reset is accomplished by cycling the POWER switch. Two indicator lamps monitor the LINE and OUTPUT voltages. The primary circuit is fused with a slo-blo fuse. The output voltage is available through a six pin Jones connector and a phono gype jack for low current applications. Two of the six Jones pins are used for remote power on-off switching, if desired. Will accept the Model [[207]] ammeter. |
| - | *Output voltage regulated at 12.5 volts, nominal. | + | |
| - | *Overload protection circuit. | + | ===== Specifications ===== |
| - | *4.5" x 8.25" x 8", 10 lbs. | + | |
| + | ***Input Voltage:** 117 VAC, 50-60 Hz. | ||
| + | ***Output Voltage:** 13 VDC, +/- 0.5 V, regulated. | ||
| + | ***Construction:** Aluminum with molded plastic side panels. | ||
| + | ***Output Connectors:** One 6 pin Jones type, one phono jack for low current, one phono jack for Model [[207]] Ammeter. | ||
| + | ***Output Current:** 9 amperes continuous, full load. 10 amperes, maximum. | ||
| + | ***Circuit Breaker:** Electronic latching. Factory set to trip at 10 A. | ||
| + | ***Ripple:** Less than 25 mV, peak-to-peak @ 9 A and 117 VAC. | ||
| + | ***Size:** HWD 4.5" x 8.25" x 8" | ||
| + | ***Weight:** 9.5 lbs. | ||
