Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision Last revision Both sides next revision | ||
228 [2007/12/04 02:41] n5na created |
228 [2008/05/13 23:34] n5na |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Antenna Tuner Model 228 ====== | ====== Antenna Tuner Model 228 ====== | ||
{{228.jpg?150|}}{{228rear.jpg?150|}} | {{228.jpg?150|}}{{228rear.jpg?150|}} | ||
+ | |||
+ | ===== Description ===== | ||
+ | The Model 228 antenna tuner is an inductive/capacitive network used for matching unbalanced 50 - 75 ohm output impedances of transmitters and transceivers to a variety of loads, both balanced and unbalanced. It operates over a frequency range of 1.8 to 30 MHz. It has a built-in antenna select switch which permits bypassing the tuner or selection of three different antennas. Model 228 has a built-in SWR bridge and meter. | ||
+ | |||
+ | ===== Specifications ===== | ||
+ | ***Circuit:** T network | ||
+ | ***RF Power:** 200 watts, intermittent; 100 watts continuous | ||
+ | ***Capacitor Voltage Rating:** 1 KV | ||
+ | ***Inductor:** 47 taps, 18 gauge silver-plated wire on a 2" diameter core | ||
+ | ***Input Impedance:** 50 - 75 ohms, unbalanced | ||
+ | ***Output:** Matches most loads, balanced and unbalanced. Maximum balanced load 1.8 to 4.0 MHz is 500 ohms. | ||
+ | ***Frequency Range:** 1.8 to 30 MHz | ||
+ | ***Finish:** Painted front and rear panel; black textured sides and top |