Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
pm1 [2007/02/18 22:35] n5na |
pm1 [2007/05/21 00:45] 127.0.0.1 external edit |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Power Mite Model PM 1 ====== | + | ====== Power-Mite Model PM 1 ====== |
| - | {{pm1.jpg?150|}} | + | {{pm1a.jpg?150|}} |
| ===== Description ===== | ===== Description ===== | ||
| Line 18: | Line 18: | ||
| *100 cycles drift. No warm-up. | *100 cycles drift. No warm-up. | ||
| + | |||
| + | ===== Related Links ===== | ||
| + | *[[http://kb.tentec.com/index.php?article=44|Ten-Tec Knowledgebase Article]] on Identifying Power Mite Transceivers | ||
| + | |||
| + | ===== Accessories ===== | ||
| + | *Keying Monitor Model [[AC2]] | ||
| + | *15 Meter Converter Model [[AC3]] | ||
| + | *Low Power SWR Meter Model [[AC4]] | ||
| + | *Low Power Antenna Tuner Model [[AC5]] | ||
| + | |||
| + | ===== Sales Information ===== | ||
| + | {{pm1_pm2_ad.jpg?100|}}{{pm2_pm3_ad.jpg?100|}} | ||
| + | |||
| + | ===== Specifications ===== | ||
| + | ***Frequency Range:** 3.475 - 4.025, 6.975 - 7.325 | ||
| + | ***Size:** HWD 4" x 10.125: x 7.5" | ||
| + | ***Shipping Weight:** 4 lbs | ||
| + | ***Power:** 12 volts. 20 ma on receive, 300 ma on transmit | ||
| + | ***Semiconductor devices:** 1 dual gate MOSFET, 1 integrated circuit, 4 silicon transistors | ||
| + | ***Type of Reception:** CW - SSB - AM | ||
| + | ***Sensitivity:** Less than one microvolt provides readable signal | ||
| + | ***Antenna input:** 50 - 75 ohms | ||
| + | ***Selectivity:** 2 KC at 6 dB down points | ||
| + | ***Audio:**Output impedance - 1000 ohms. Frequency response - +/- 3 dB 200 Hz - 2500 Hz | ||
| + | ***Frequency stability:** Less than 100 Hz drift | ||
| + | ***Transmitter:** Power - 2 watts input. Output impedance 50 - 75 ohms, fixed link | ||
| + | ***Headphones:** Front panel tip jacks are provided | ||
| + | ***Key:** Phono jack is provided on rear apron | ||
| + | ***Crystal:** A crystal socket is provided on the front panel. The socket accepts holders of the HC6U type or any crystal with 0.486 inch spacing and 0.050 diameter pins. | ||
