Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
omni30mmod [2017/04/29 13:51] n1ooq |
omni30mmod [2017/04/29 14:10] n1ooq |
||
|---|---|---|---|
| Line 53: | Line 53: | ||
| ==Adding the bandpass filter to the board== | ==Adding the bandpass filter to the board== | ||
| + | The stack is hot-melt glued to the bandpass filter board. It is attached vertically in approximately the same position as the Tentec transformer can for the original mod. There is a resistor which must be moved - see the Tentec instruction sheet. | ||
| - | Bandpass board, bottom side, showing pads for 30m mod: {{:img0025a_-_edit.jpg?100}} | + | Bandpass board, bottom side, showing pads for 30m mod. At left, output. At the center, ground. At right, input: {{:img0025a_-_edit.jpg?100}} |
