Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
234align [2011/12/14 20:35] n1eu |
234align [2011/12/14 21:46] n1eu |
||
---|---|---|---|
Line 1: | Line 1: | ||
===== Alignment Procedure for 234 Speech Processor ===== | ===== Alignment Procedure for 234 Speech Processor ===== | ||
+ | |||
+ | //(from Ten-Tec service dept with notes in italic by N1EU)// | ||
1. Hook up to rig as normal with no input (no mic connected) | 1. Hook up to rig as normal with no input (no mic connected) | ||
Line 8: | Line 10: | ||
3. Attach scope to junction of R18 and R19 on Clipper-Detector board (rear | 3. Attach scope to junction of R18 and R19 on Clipper-Detector board (rear | ||
- | board). Note: R18 is immediately in front of crystal Y-1. | + | board). Note: R18 is immediately in front of crystal Y-1. //(looking from front, Y-1 is the back left xtal and R19 is immediately in front of and at right angles to R18)// |
- | * Turn R33 BALANCE pot on SSB board fully CW. | + | * Turn R33 BALANCE pot on SSB board //(front board)// fully CW. //(looking from front, R33 is back right pot)// |
- | * Peak T-1 for maximum output. | + | * Peak T-1 for maximum output. //(immediately right of two xtals)// |
* Turn R-33 back CCW for a null in output. | * Turn R-33 back CCW for a null in output. | ||
- | 5. Attach counter to TP1 (coax) on SSB Board. This is the center conductor of the coax that carries the BFO signal from the SSB board to the Clipper-detector board. | + | 5. Attach counter to TP1 (coax) on SSB Board. This is the center conductor of the coax that carries the BFO signal from the SSB board to the Clipper-detector board. //(looking from front, on right side of board)// |
- | Turn front panel passband control fully CCW and adjust C-14 for 6.100220 MHz (that is, 220 Hz above 6.1 MHz). | + | * Turn front panel passband control fully CCW and adjust C-14 for 6.100220 MHz (that is, 220 Hz above 6.1 MHz). |
- | Turn passband control back fully CW. Frequency should drop to approximately 6.099780 (that is, 220 Hz below 6.1 MHz). | + | * Turn passband control back fully CW. Frequency should drop to approximately 6.099780 (that is, 220 Hz below 6.1 MHz). |
Note: the procedure is to approximately center the passband around 6.1 MHz. Slight adjustment of C-14 may be needed. | Note: the procedure is to approximately center the passband around 6.1 MHz. Slight adjustment of C-14 may be needed. | ||
- | 6. Turn passband control back to center, or position so that your voice | + | 6. Turn passband control back to center, or position so that your voice sounds normal to someone who knows your voice. Note: turning the passband control CCW increases the treble, while turning the control CW increases bass. This is counter intuitive and not mentioned in the manual. |
- | sounds normal to someone who knows your voice. Note: turning the passband | + | |
- | control CCW increases the treble, while turning the control CW increases | + | {{:234pcb.jpg?300|}} |
- | bass. This is counter intuitive and not mentioned in the manual. | + | |