Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
1254pbigelow [2007/03/27 16:40] n5na created |
1254pbigelow [2007/03/27 16:45] n5na |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| **Features:** | **Features:** | ||
| - | 1. Great sensitivity (compared against the NRD-525) and the sensitivity is relatively consistent across the 100kc-30000kc receiving range. | + | - Great sensitivity (compared against the NRD-525) and the sensitivity is relatively consistent across the 100kc-30000kc receiving range. |
| - | 2. Good selectivity (for a 4kc filter) | + | - Good selectivity (for a 4kc filter) |
| - | 3. Reasonably stable | + | - Reasonably stable |
| - | 4. Excellent quality boards | + | - Excellent quality boards |
| - | 5. Easy to service (except for removing parts from the plated through holes) | + | - Easy to service (except for removing parts from the plated through holes) |
| - | 6. Convenient to use | + | - Convenient to use |
| - | 7. Informative, relatively easy to follow instructions | + | - Informative, relatively easy to follow instructions |
| **Suggested change:** | **Suggested change:** | ||
| Line 20: | Line 20: | ||
| **Quirks noted and possible remedies:** | **Quirks noted and possible remedies:** | ||
| - | 1.) Lots of birdies and display induced signals on the lower half of the AM broadcast band. | + | - Lots of birdies and display induced signals on the lower half of the AM broadcast band. |
| - | Remedy: Have attempted to shield out the multiplexing emissions by spray painting a graphite EMI/RF shield to the inside of the front cover. It helped a little bit. | + | |
| - | 2.) Reduced sensitivity on the lower half of the AM broadcast band. | + | * Remedy: Have attempted to shield out the multiplexing emissions by spray painting a graphite EMI/RF shield to the inside of the front cover. It helped a little bit. |
| - | Remedy: Put a jumper across R72, eliminating that input filter. | + | |
| - | 3.) FM intermod from strong FM stations. Just add 90 (2* 1st IF) to the received frequency | + | - Reduced sensitivity on the lower half of the AM broadcast band. |
| + | |||
| + | * Remedy: Put a jumper across R72, eliminating that input filter. | ||
| + | |||
| + | - FM intermod from strong FM stations. Just add 90 (2* 1st IF) to the received frequency | ||
| to detetmine offending frequency. | to detetmine offending frequency. | ||
| + | |||
| Remedy: Have tried with some success (but none totally satisfactory): | Remedy: Have tried with some success (but none totally satisfactory): | ||
| - | a) Snap-on RF choke on power cable | + | |
| - | b) Soldered on a shield on trace side of the board around the 1st Mixer section | + | * Snap-on RF choke on power cable |
| - | c) Incorporated FM trap (from Radio Shack) in the antenna lead | + | |
| - | 4.) The rotary Encoder loosens up with use causing the frequencies to jump around (sometimes) when tuning from one step to another. | + | * Soldered on a shield on trace side of the board around the 1st Mixer section. |
| - | Possible Remedy (have not tried yet): Sandwiching a large, black, felt washer between the tuning knob and the tuning knob recess to reduce play. | + | |
| - | 5. ) Hum from the power supply. | + | * Incorporated FM trap (from Radio Shack) in the antenna lead. |
| - | Possible Remedy (have not tried yet): Install a 15V IC regulator in the power supply. | + | |
| - | 6.) Deafening thump upon turning on the 1254 when using headphones. REALLY LOUD. | + | - The rotary Encoder loosens up with use causing the frequencies to jump around (sometimes) when tuning from one step to another. |
| - | Remedy: None yet although I suspect a large capactior may resolve this one. | + | |
| - | 7.) A little bit of "thumping" due to slow synthesizer lock. Not too bad, really, considering | + | * Possible Remedy (have not tried yet): Sandwiching a large, black, felt washer between the tuning knob and the tuning knob recess to reduce play. |
| + | |||
| + | - Hum from the power supply. | ||
| + | |||
| + | * Possible Remedy (have not tried yet): Install a 15V IC regulator in the power supply. | ||
| + | |||
| + | - Deafening thump upon turning on the 1254 when using headphones. REALLY LOUD. | ||
| + | |||
| + | * Remedy: None yet although I suspect a large capactior may resolve this one. | ||
| + | |||
| + | - A little bit of "thumping" due to slow synthesizer lock. Not too bad, really, considering | ||
| the price. | the price. | ||
| Paul | Paul | ||
