-- |
TenTec Corsair sinewave sidetone modification
by Steve Ellington, N4LQ
The sidetone in the Corsair produces a sawtooth
wave, rich in harmonics and is unpleasant to listen to for most of us.
Fortunately, there is a very easy solution.
The Corsair has two audio oscillators. One is the sidetone, activated when you
close the key and the other is the spot feature, activated by pushing the spot
button. Push the spot button and notice how pure it sounds. This is a sine wave
oscillator. We are going to use this for our CW sidetone.
The process is very simple:
-
Turn the Corsair over. Remove the Corsair's bottom cover.
-
With the Corsair's front panel facing you, locate the IF/AF
board. It is on the right, front side of the rig.
-
Locate connector 28. It is located on the left, front side of
the IF/AF board.
-
Using a piece of wire, short the two outer pins of connector 28
together. I pulled the connector off, stuck the fine wire inside each outer hole
and plugged it back in taking care not to allow the jumper to contact the center
pin. This could be done from the top of the plug. It's you're preference.
-
Turn the volume down completely on the original sidetone.
-
Key the rig and adjust R2 for proper pitch and R3 for desired
volume.
Further refinements:
-
To clean up some of the audio thumps, solder a .22uf (224)
capacitor between the center wiper of R2 and ground. I obtained ground from
the lug on the PTO.
- The original sidetone will leak some of it's nasty tone even when turned
down to minimum. I grounded the front end of R4 which totally kills the beast.
Use the PTO lug for ground. There are other solutions but this one is easily
undone.
Side effects:
The sidetone will now sound very clean. Adjusting the pitch and volume will not
be as easy unless you knock out a hole in the chassis under R2 and R3.
Pushing the spot button will still produce the tone but it will be slightly
different from the sidetone's pitch. This could be compensated for very
easily by installing a trimmer pot in series with the spot button however I
seldom have need for the spot button and the difference is very slight.
Corsair II.
The Corsair II's spot button functions totally differently. Instead of
keying another oscillator, it changes the frequency of the BFO. So from
what I can tell by the schematic this mod will only work with the older Corsair.
Note: When I aligned the BFO oscillators, I set the offset for 600hz instead of
the factory 750hz because I prefer the lower pitch. To adjust the new
sidetone, you can connect a frequency counter to the speaker and adjust for
600hz a pitch. This is strictly user preference.
Note 2. Using an MFJ-281 ClearTone speaker will produce beautiful CW and really
reduce some of the annoying thumps associated with the Corsair's AGC and QSK
system.
RETURN |