Power-Mite Model PM 1
Description
The MX1, AA1, VO1, and TX1 modules are wired into a band-switching 80-40 meter CW transceiver. Front panel controls: On-off, Transmit-Receive, Receiver Resonate, VFO-Crystal, Bandswitches, Oscillator tuning, Final Resonate. A meter is provided to monitor final amplifier current.
- 40-80 meters. 15 meter converter available.
- Crystal control or transceive operation (Transceive on 40-80 meters, crystal only on 15 meters.)
- Slide-rule dial. Flywheel tuning.
- Power - 12 volt lantern battery.
- Front panel band switching.
- Shaped audio - 200-2500 Hz.
- Metered power amplifier stage.
- Silicon transistors. Integrated circuit.
- 2 KHz receiving band width
- 2 watts input to final stage
- 100 cycles drift. No warm-up.
Related Links
- Ten-Tec Knowledgebase Article on Identifying Power Mite Transceivers
Accessories
Sales Information
Specifications
- Frequency Range: 3.475 - 4.025, 6.975 - 7.325
- Size: HWD 4" x 10.125: x 7.5"
- Shipping Weight: 4 lbs
- Power: 12 volts. 20 ma on receive, 300 ma on transmit
- Semiconductor devices: 1 dual gate MOSFET, 1 integrated circuit, 4 silicon transistors
- Type of Reception: CW - SSB - AM
- Sensitivity: Less than one microvolt provides readable signal
- Antenna input: 50 - 75 ohms
- Selectivity: 2 KC at 6 dB down points
- Audio:Output impedance - 1000 ohms. Frequency response - +/- 3 dB 200 Hz - 2500 Hz
- Frequency stability: Less than 100 Hz drift
- Transmitter: Power - 2 watts input. Output impedance 50 - 75 ohms, fixed link
- Headphones: Front panel tip jacks are provided
- Key: Phono jack is provided on rear apron
- Crystal: A crystal socket is provided on the front panel. The socket accepts holders of the HC6U type or any crystal with 0.486 inch spacing and 0.050 diameter pins.