Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
962 [2007/02/13 15:09] n5na |
962 [2019/03/18 14:59] n5na [Description] |
||
---|---|---|---|
Line 2: | Line 2: | ||
{{962.jpg?150|}} | {{962.jpg?150|}} | ||
+ | |||
+ | |||
===== Description ===== | ===== Description ===== | ||
The Model 962 Power Supply is designed to power the TEN-TEC Models [[560]]/[[561]]/[[563]]/[[564]] and [[585]] transceivers. The supply delivers 20 amps at 13.5 Vdc from a 115/230 Vac 50/60 Hz source. Circuit features include an electronic over-current sensor which shuts off the output if the current demand exceeds 22 amps. The over-current shut down condition is reset by cycling the POWER switch from ON to OFF and back to ON. | The Model 962 Power Supply is designed to power the TEN-TEC Models [[560]]/[[561]]/[[563]]/[[564]] and [[585]] transceivers. The supply delivers 20 amps at 13.5 Vdc from a 115/230 Vac 50/60 Hz source. Circuit features include an electronic over-current sensor which shuts off the output if the current demand exceeds 22 amps. The over-current shut down condition is reset by cycling the POWER switch from ON to OFF and back to ON. | ||
- | The output voltage is available through a4 x 14 guage 3 foot cable and connector. The cable carries +13.5 Vdc, ground and the "hot" side of the AC primary and mates directly to the POWER jack on the [[560]]/[[561]]/[[563]]/[[564]] and [[585]] transceivers with a 4 pin AMP MATE-N-LOC connector. Two RCA phono jacks on the back of the supply also provide +13.5 Vdc for low current (2 or 3 amps) auxiliary applications. | + | The output voltage is available through a 4 x 14 guage 3 foot cable and connector. The cable carries +13.5 Vdc, ground and the "hot" side of the AC primary and mates directly to the POWER jack on the [[560]]/[[561]]/[[563]]/[[564]] and [[585]] transceivers with a [[80572|4 pin AMP MATE-N-LOC]] connector. Two RCA phono jacks on the back of the supply also provide +13.5 Vdc for low current (2 or 3 amps) auxiliary applications. |
+ | |||
+ | {{962_schematic.pdf | 962 Power Supply Schematic from WB4JTR}} | ||
+ | |||
+ | From WB4JTR - In the 962, the regulator pass element was moved to the negative side of the bridge so that the collectors of the power transistors could be grounded -- eliminating the requirement for the mica insulators and protective plastic covers. | ||