Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
961spkr [2007/03/28 16:08]
n5na created
961spkr [2007/03/29 09:32]
n5na
Line 1: Line 1:
 ====== Improved Speaker Audio from Model 961 ====== ====== Improved Speaker Audio from Model 961 ======
-**From the Ten Tec Reflector December 11, 1998**+**From the Ten-Tec Reflector December 11, 1998**
  
 Hi all, i thought that maybe i would share a mod i made about 6 months or so ago to my ten tec 961 speaker & power supply to get a little bit better sounding audio and volume. Hi all, i thought that maybe i would share a mod i made about 6 months or so ago to my ten tec 961 speaker & power supply to get a little bit better sounding audio and volume.
Line 10: Line 10:
 The whole project consists of four pieces of 3/16" masonite,​(you could use what ever you have laying around!)acutally,​ you can make five pieces if you want to box in the bottom to. I'll give the dimemsions below,and if you cut the pieces a little big, then file to fit,you will see that they will only fit one way ! with the two side pieces fitting between the four (two per side)speaker screws protruding out the back side of the speaker face. The whole project consists of four pieces of 3/16" masonite,​(you could use what ever you have laying around!)acutally,​ you can make five pieces if you want to box in the bottom to. I'll give the dimemsions below,and if you cut the pieces a little big, then file to fit,you will see that they will only fit one way ! with the two side pieces fitting between the four (two per side)speaker screws protruding out the back side of the speaker face.
  
-  *one back piece                        5"x3-5/8"x3/16" +  *one back piece5" ​x 3-5/​8" ​x 3/16" 
-  *two side pieces, left and right side  3-5/8"x1-5/16"x3/16" +  *two side pieces, left and right side3-5/​8" ​x 1-5/​16" ​x 3/16" 
-  *one top piece                         ​4-13/​16"​x1-5/8"x3/16"+  *one top piece4-13/​16" ​x 1-5/​8" ​x 3/16"
  
 you can put in the optional bottom piece, or leave it out, i really did not notice much difference. Also, after you get all of the pieces cut and filed to size, you can put a little glue on the pieces, you will also have to put a little notch in the bottom of the back piece for the speaker wire to run under,so when your done, the whole darn box should slide right over the speaker !! custom fit !! and you have not changed anything on the outside, it just ends up sounding better and louder ! you can put in the optional bottom piece, or leave it out, i really did not notice much difference. Also, after you get all of the pieces cut and filed to size, you can put a little glue on the pieces, you will also have to put a little notch in the bottom of the back piece for the speaker wire to run under,so when your done, the whole darn box should slide right over the speaker !! custom fit !! and you have not changed anything on the outside, it just ends up sounding better and louder !

QR Code
QR Code 961spkr (generated for current page)