Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
599 [2010/11/10 22:50] n5na |
599 [2010/11/25 18:23] n5na [General] |
||
---|---|---|---|
Line 7: | Line 7: | ||
HF plus 6 meters transceiver along with general coverage receive. Dual VFO’s with SPLIT mode and 100 memories, passband tuning, adjustable AGC, variable CW offset, RIT, built in CTCSS tones for 6 meter FM and QSK. | HF plus 6 meters transceiver along with general coverage receive. Dual VFO’s with SPLIT mode and 100 memories, passband tuning, adjustable AGC, variable CW offset, RIT, built in CTCSS tones for 6 meter FM and QSK. | ||
+ | ===== Related Links ===== | ||
+ | *[[http://groups.yahoo.com/group/TenTec_Eagle/|Eagle Yahoo Group]] | ||
+ | |||
+ | ===== Specifications ===== | ||
+ | |||
+ | ==== General ==== | ||
+ | |||
+ | ***Microphone Connector:** 8-Pin | ||
+ | ***Headphone Jack:** 1/4" Stereo, accepts mono or stereo plug. | ||
+ | ***External CW Key Jack:** 1/8 " Stereo | ||
+ | ***External Speaker Jack:** 1/8" Mono | ||
+ | ***Aux DC Output Connector:** RCA x 2 | ||
+ | ***Frequency Range TX:** Ham Bands Only (160-6M) | ||
+ | ***ACC Din Connector:** 8 PIN DIN Connector - Line In, Line Out, Aux PTT, Ext Key, Clock/Data/Enable, Ground | ||
+ | ***DC Power Connector:** Power Pole | ||
+ | ***Fuse:** Automotive Blade Style Fuse, 25 Amp 32V | ||
+ | ***Frequency Range RX:** 500 kHz - 30 MHz and 50 - 54MHz. Specifications apply within Amateur Radio bands only. | ||
+ | ***Tuning Step Size:** 1, 10, 100, 1000, 10000 | ||
+ | ***Frequency Stability:** Maximum +/- 0.5 PPM over operating temperature | ||
+ | ***Antenna Impedance:** 50 ohms nominal. | ||
+ | ***Antenna Connectors:** 1 x SO-239 transceive | ||
+ | ***Modes:** USB, LSB, CW, AM (optional), FM (optional) | ||
+ | ***Memories:** 100 | ||
+ | ***Frequency Accuracy:** +-5Hz @25C, 1 Hz tuning resolution | ||
+ | ***Supply Voltage Range:** 13.8V +/-15% | ||
+ | ***Operating Temp. Range:** 0-50 degrees Celsius | ||
+ | ***Dimensions (H x W x D):** 2.9" x 8.5" x 10.25" (excluding knobs and connectors) | ||
+ | ***Weight:** 7.25 lbs with all options | ||
+ | ***Construction:** Molded plastic front panel, aluminum chassis and texture painted steel covers | ||
+ | ***PC Control Port:** USB (using CCS USB to UART Driver) | ||
+ | ***Display:** Custom FSTN monochrome LCD | ||
+ | ***Display Backlight:** 256 colors X 16 intensity levels | ||
+ | |||
+ | ==== Receiver ==== | ||
+ | |||
+ | ***SSB Sensitivity:** Better than 0.7uV, 2.4khz, 10dB SINAD, preamp off | ||
+ | ***AM Sensitivity:** Better than 4uV, 30% Mod, 6kHz BW, 10dB SINAD, preamp off | ||
+ | ***FM Sensitivity:** Better than 2.2uV, 5kHz Dev, 16kHz BW, 10dB SINAD, preamp off | ||
+ | ***Selectivity IF1:** 2.4khz standard, 9.0015 MHz, 2 options | ||
+ | ***Selectivity IF2:** 30 KHz Lowpass filter | ||
+ | ***Selectivity, DSP IF:** 127 built-in DSP filters from 100-15000 Hz BW | ||
+ | ***Third Order Intercept Point (IP3):** Typical 20dBm @ 20kHz tone separation/2.4 kHz roofing filter, 17dBm @ 2kHz separation/600Hz roofing filter, S5 method, preamp off | ||
+ | ***IMD3 Dynamic Range:** Typical 97dB/20kHz, 95dB/2kHz, 500Hz BW, calculated 2/3(IP3-Noise Floor), preamp off | ||
+ | ***Blocking Dynamic Range:** 138dB/20kHz, 127dB/2kHz, 500 Hz BW, RF gain @ 12 o'clock, preamp off | ||
+ | ***LO Phase Noise:** Typical -132dBc/Hz @ 20kHz, -121dBc/Hz @ 2kHz | ||
+ | ***Noise Floor:** Typical -132dBm/500Hz BW/preamp on, -126dBm preamp off | ||
+ | ***IF Frequencies:** 1st:9.0015 MHz, 2nd:22.5 kHz, 3rd:0Hz (DSP) | ||
+ | ***IF Rejection:** Better than 70dB | ||
+ | ***1st IF Image Rejection:** Better than 90dB/HF bands, 70dB/6M | ||
+ | ***2nd IF Image Rejection:** Better than 73dB | ||
+ | ***Other Spurious Response Rejection:** Rejection:>80dB | ||
+ | ***Other Spurious Response Rejection:** Birdies: Typically less than -100dBm equivalent (no more than 5 birdies greater than -100dBm equivalent) | ||
+ | ***Pass Band Tuning:** +/- 2.1kHz, 5Hz steps. Small dead zone for centering | ||
+ | ***Attenuator:** 10 db | ||
+ | ***PreAmp:** Nominal 12 db | ||
+ | ***Audio Output:** 2W into 4 ohms, <3% THD | ||
+ | ***RIT range:** +/- 8.2 kHz | ||
+ | ***RIT Step size:** 10Hz | ||
+ | ***S-Meter Reference:** S9 = 50 uV RMS | ||
+ | ***TX>RX Recovery Time:** < 20 ms | ||
+ | ***RX Headphone Output:** Designed for 16-32 ohms impedance headphones. Usable at 8 ohms | ||
+ | ***AUX Audio Output:** 500 mv | ||
+ | ***Auto Notch:** IF DSP, multi-tone | ||
+ | ***RX Noise Reduction:** IF DSP, adjustable | ||
+ | ***Noise Blanker:** Optional daughter board, 2 levels of blanking | ||
+ | ***RX Current Drain:** 1.25 Amps | ||
+ | ***General Coverage Receive:** degraded specs outside ham bands | ||
+ | |||
+ | ==== Transmitter ==== | ||
+ | |||
+ | ***RF Power Output:** Adjustable, 5-100 W, +/- 1 dB | ||
+ | ***CW & SSB Duty Cycle:** continuous service @ 100W | ||
+ | ***AM,FM,AFSK,PSK Duty Cycle:** continuous service @100W, 50% duty cycle (Tx/Rx) | ||
+ | ***CW/SSB TX Bandwidth:** 2.4kHz Filter | ||
+ | ***AM TX Bandwidth:** 6k | ||
+ | ***FM TX Bandwidth:** 15kHz Optional Filter | ||
+ | ***Microphone Input Impedance:** >10 k-ohms at 1 kHz | ||
+ | ***Microphone Sensitivity:** 1 mV RMS for full power output, internal gain adjustment, 9v dc power for electret elements | ||
+ | ***FM Deviation:** +/- 5 kHz peak nominal | ||
+ | ***AUX Level Input:** variable, 200mV nominal | ||
+ | ***SSB Carrier Supression:** > 70 dB | ||
+ | ***Unwanted Sideband Suppression:** > 60 dB at 1 kHz | ||
+ | ***Harmonic & Spurious Outputs:** <-50dBc @100 W <30MHz; -60dB>30MHz; -43 dB <5 W | ||
+ | ***T/R Switching:** PTT or VOX on SSB, AM, FM, QSK on CW | ||
+ | ***CW Keyer Type:** Internal Curtis Mode B | ||
+ | ***CW Rise and Fall Times:** 5ms | ||
+ | ***CW Offset:** adjustable | ||
+ | ***CW Keyer Speed:** 5-60 WPM, adjustable weighting | ||
+ | ***Current Drain:** transmit 20 amps typ. | ||
+ | ***Third Order Intermod:** Better than 25dB below peak | ||
+ | ***SSB Generation:** DSP Generated | ||
+ | ***No. of DSP generated TX bandwidths:** 3 built-in DSP filters - automatically selected - standard = 2.4Khz for SSB/CW; optional = 6Khz for AM, 12Khz for FM | ||
+ | |||
+ | ==== Antenna Tuner ==== | ||
+ | |||
+ | ***Type:** Reversible L-network | ||
+ | ***Matching frequency range:** 160 to 10 Meters, no Six Meters | ||
+ | ***Matching impedance range:** 10:1 SWR typical | ||
+ | |||
+ | ==== Options ==== | ||
+ | |||
+ | ***Filters:** 2.4K standard, optional = 300, 600, 1.8k, 6k, 15k | ||
+ | ***Noise Blanker:** daughter board module | ||
+ | ***Auto Tuner:** daughter board module |