This is an old revision of the document!


Paragon II Audio BP Fade Feature Mod

From the Ten-Tec Reflector December 19, 2004

If you have a Paragon II and feel that the Fade - BP audio is broad and ineffective, check the following value on the IF/AF board. This board is located on the bottom/front RH side. You must remove the bottom shield of course.

R65 should be a 33k according to the schematic. Mine was a 3.3K. This incorrect value prevented the first stage of the filter from resonating near the desired frequency while the second stage worked fine, since it had the correct value, 33k.

Have you noticed how the audio gain seems to decrease when turning up the fade control, even at resonance? Change R64 from 33k to 10k. This will equalize the gain when the filter is engaged.

Once the filter is working properly, it becomes a wonderful tool for improving CW copy.

73
Steve N4LQ


QR Code
QR Code 586audiobp (generated for current page)