Differences

This shows you the differences between two versions of the page.

Link to this comparison view

586audiobp [2007/04/18 18:08]
n5na created
586audiobp [2007/05/21 00:44]
Line 1: Line 1:
-====== Paragon II Audio BP Fade Feature Mod ====== 
-**From the Ten-Tec Reflector December 19, 2004** 
  
-If you have a Paragon II and feel that the Fade - BP audio is broad and ineffective,​ check the following value on the IF/AF board. This board is located on the bottom/​front RH side. You must remove the bottom shield of course. 
- 
-R65 should be a 33k according to the schematic. Mine was a 3.3K. This incorrect value prevented the first stage of the filter from resonating near the desired frequency while the second stage worked fine, since it had the correct value, 33k.  
- 
-Have you noticed how the audio gain seems to decrease when turning up the fade control, even at resonance? Change R64 from 33k to 10k. This will equalize the gain when the filter is engaged. ​ 
- 
-Once the filter is working properly, it becomes a wonderful tool for improving CW copy.  
- 
-73\\  
-Steve N4LQ 

QR Code
QR Code 586audiobp (generated for current page)