This is an old revision of the document!


Paragon Model 585

Description

All solid state microprocessor controlled HF transceiver covering all amateur bands on transmit and general coverage receive from 100 kHz to 29.999 MHZ.

Reviews

  • ARRL (Must be an ARRL member and logged in to view.)
  • CQ Magazine, 1988, Part I - April Pg 44, Part II - May Pg 52, Part III - June Pg 46

Mods / Fixes

Accessories

  • Power Supply Model 960
  • Voice Readout Model 257
  • RS232 Interface Model 258
  • FM Adapter Model 256
  • 1.8 kHz SSB Filter Model 288
  • 500 Hz CW Filter Model 285
  • 250 Hz CW Filter Model 282

Some Basic Differences Between Paragon Model 585 and Paragon II Model 586

  • Paragon II 586 includes both AM and FM transmit and receive, the Paragon 585 needs an additional FM board to run FM transmit.
  • The Paragon 585 will receive AM but not transmit AM. The Paragon II 586 will both transmit and receive on AM.
  • The Paragon II has a Omni VI style front button set with a more advanced logic design circuitry to allow for band stacking registers like the Omni VI.
  • The Paragon II has more advanced RS-232 interface/logic design to allow for the Icom style logging programs to be run. The Paragon 585 requires an optional RS232 Interface Model 258 and runs a different command set.

Specifications

General

  • Frequency Range: Receive: 100 kHz to 29.999 Mhz. Transmit: Standard Ham Bands 160m - 10m (Note: For operation outside Ham Bands contact factory.).
  • Frequency Control: Microprocessor controlled digital PLL synthesizer. 10 Hz resolution.
  • Frequency Readout: 7 digit 10 Hz fluorescent readout.
  • Frequency Stability: Worst case, 1 PPM per degree C at 29.999 MHz.
  • Antenna Impedance: 50 ohm unbalanced.
  • Power Required: Receive - approx. 1.5 A. Transmit - approx. 20 A. @ 13.8 VDC.
  • Construction: Rigid aluminum chassis. Extruded aluminum front panel. Textured top and bottom, snap up stainless steel bail.
  • Dimensions: HWD 5.75" x 14.75" x 17" (14.6 x 37.4 x 43.2 cm)
  • Net Weight: 16 lbs (7.25 kg).

Transmitter

  • Modes: USB, LSB, CW, RTTY (FSK or AFSK), (FM optional).
  • DC Power Input: Maximum 200 watts @ 14 VDC CW, SSB, (FM). 100% duty cycle for up to 20 minutes. Continuous with auxiliary air cooling.
  • RF Power Output: 25 to 100 watts adjustable with front panel RF PWR control.
  • Microphone Input: High/Low impedance. Four pin, front panel connector accepts microphones with 5 mV (-62 dB) output. Polarizing voltage is provided for electrets.
  • T/R Switching: VOX or PTT on SSB. Switchable FAST or SLOW QSK on CW.
  • CW Sidetone: Internally generated, adjustable tone and volume independant of AF GAIN control.
  • SSB Generation: 9 MHz, 8-pole crystal ladder filter. Balanced modulator.
  • Carrier Suppression: 60 dB typcial.
  • Unwanted Sideband Suppression: 60 dB typical at 1.5 kHz tone.
  • Spurious Output: More than 45 dB below peak power output.
  • Meter: Switchable forward power, SWR, collector current, audio processing level.
  • CW Offset: 750 Hz automatic.
  • FSK Shift: 170 Hz.

Receiver

  • Modes: USB, LSB, CW, FSK/AFSK, AM (FM optional).
  • Sensitivity:
Mode Frequency, MHz
0.1 - 1.6 1.6 - 29.999
SSB, CW, RTTY 0.5 uV 0.15 uV 10 dB S/N @ 2.4 kHz
AM 3.5 uV 1.00 uV 10 dB S/N @ 6.0 kHz
(FM) 1.00 uV 0.30 uV 12 dB SINAD @ 15 kHz
  • Selectivity:
Filter Selectivity
-6 dB -60 dB
Standard 2.40 kHz 3.36 kHz
AM 6.00 kHz 11.25 kHz
Optional 1.80 kHz 2.90 kHz
Optional .50 kHz 1.40 kHz
Optional .25 kHz .85 kHz
(FM) 15 kHz 30 kHz
  • Attenuator: Approx. -20 dB for 1.6 to 29.999 MHz, -10 dB for 0.1 to 1.6 MHz.
  • I-F Frequencies: 1st - 75 MHz, 2nd - 9.0 MHz, 3rd - 6.3 MHz (FM 3rd - 455 kHz).
  • RX Antenna Input: Switchable 50 ohm phono jack.
  • Image Rejection: >80 dB.
  • I-F Rejection: >70 dB.
  • Noise Blanker: Switchable on/off with adjustable width.
  • S-Meter: Automatically switched on during receive. Calibrated to 50 uV at S9.
  • Dynamic Range: 100 dB typical.
  • 3rd Order ICP: +18 dBm.
  • Squelch Sensitivity: AM, CW, SSB, FSK (1.6 - 29.999 MHz) - Less than 1 uV. Optional FM (1.6 - 29.999 MHz) - Less than 0.4 uV.
  • Pass Band Tuning: +/- 1.2 kHz.
  • Audio Output: 1.5 watts @ 8 ohm with less than 2% distortion.
  • Notch Filter: 250 to 2.2 kHz, 50 dB notch typical.
  • Audio Bnadpass Filter: 4 pole, variable center frequency 220 to 1.7 kHz, 35% bandwidth @ -6 dB. Variable fader control selects filtered or flat audio response.
  • Tone Control: Variable 15 dB rolloff @ 5 kHz.

QR Code
QR Code 585 (generated for current page)