Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
565ritencoder [2017/03/15 18:12] n1eu |
565ritencoder [2018/10/28 17:33] n5na |
||
---|---|---|---|
Line 6: | Line 6: | ||
See Also:\\ | See Also:\\ | ||
- | http://www.ve7tk.com/Orion%20RIT%20Encoder%20Replacement.pdf | + | http://www3.telus.net/ve7tk/Orion%20RIT%20Encoder%20Replacement.pdf |
---- | ---- | ||
Line 16: | Line 16: | ||
This did complicate things a bit, but did solve the problem I knew I had with one, and made one other work much smoother. | This did complicate things a bit, but did solve the problem I knew I had with one, and made one other work much smoother. | ||
- | |||
- | KE5C made a series of photos detailing how to get to the encoder board and replace an encoder (http://www.ve7tk.com/Orion%20RIT%20Encoder%20Replacement.pdf). This is a very good starting point. I've listed some details I had to deal with replacing them all. | ||
One additional thing I ran into: The VFO A and B encoder shafts pass through a bearing. The knob screws had been tightened down so tightly, that a 'nick' was left on the shafts; large enough to not allow it pass through the bearing. I had to polish this down to get these encoders out. | One additional thing I ran into: The VFO A and B encoder shafts pass through a bearing. The knob screws had been tightened down so tightly, that a 'nick' was left on the shafts; large enough to not allow it pass through the bearing. I had to polish this down to get these encoders out. |