Orion Internal Contrast Control

  • Remove the Orion’s covers (4 #2 Phillips and 18 #10 Torx screws )
  • Turn on the Orion and confirm that the software CONTRAST in the OTHER menu is set for 50% (This is the factory default value.)
  • Set the Orion on your bench with the bottom side facing up
  • The hardware CONTRAST adjusting potentiometer is located in a hole about an inch back from the front panel on the bottom side of the Orion near the MODE button. Adjust for best display.

QR Code
QR Code 565contrast (generated for current page)