Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
562amprelay [2007/03/27 18:15] n5na created |
562amprelay [2007/03/29 09:33] n5na |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Omni V Disable Amp Relay Mod ====== | ====== Omni V Disable Amp Relay Mod ====== | ||
- | **From Ten Tec Reflector July 4, 1998** | + | **From Ten-Tec Reflector July 4, 1998** |
I installed an SPST toggle switch on the upper left corner of the back panel (above all the connections. I interuppted the signal to the base of the relay driver transistor and ran it through the switch. I can reach over the radio and toggle the switch when I want to engage the amp. Otherwise I operate with the relay silenced. | I installed an SPST toggle switch on the upper left corner of the back panel (above all the connections. I interuppted the signal to the base of the relay driver transistor and ran it through the switch. I can reach over the radio and toggle the switch when I want to engage the amp. Otherwise I operate with the relay silenced. | ||
Line 9: | Line 9: | ||
Best wishes de John, WA5TWL | Best wishes de John, WA5TWL | ||
+ | |||
+ | |||
+ | **From the Ten-Tec Reflector July 6, 1998** | ||
+ | |||
+ | I have done the same as John, except I didn't mount my switch on the rear panel. | ||
+ | |||
+ | Instead, I found (after a lot of head scratching) a spot to get through the rear panel with a piece of RG-174 and have the switch lying underneath the front of the radio, just behind the bail wire. I sneaked through the rear panel beside the power connector. There's plenty of space for a couple of conductors, but I | ||
+ | used RG-174. | ||
+ | |||
+ | Ciao, | ||
+ | |||
+ | Jay/KM6VX |