Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
539 [2018/11/01 03:03] n5na |
539 [2018/11/01 03:11] n5na [Argonaut VI Model 539] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Argonaut VI Model 539 ====== | + | ====== Argonaut VI Model 539 QRP Transceiver ====== |
{{539.jpg?150|}}{{539rear.jpg?150|}} | {{539.jpg?150|}}{{539rear.jpg?150|}} | ||
+ | |||
+ | |||
+ | ===== Features ===== | ||
+ | *Modes: CW, LSB, USB, AM, Digital | ||
+ | *QSK | ||
+ | *5-50 wpm Internal CW Keyer | ||
+ | *Typical receiver sensitivity: < 1 uv | ||
+ | *DSP Selectivity: 100 built in DSP filters from 100Hz. | ||
+ | *Dynamic Range: 91db@2KHz | ||
+ | *Display: Multicolor back lit LCD | ||
+ | *RF Output power: 1 to 10 watts | ||
+ | *Frequency Coverage: 160 through 10 meters with the exception of 60 and 12 meters. | ||
+ | *Power Requirements: 9.5-14 Volts DC (550ma on receive, 3 amps at 10 watt TX) | ||
+ | *Dual “VFOs” for single or split operation | ||
+ | *Speed Sensitive VFO tuning rate | ||
+ | *Software Defined Buttons | ||
+ | *Standard 2.5 Khz roofing filter included | ||
+ | *Digital Mode operation with the TEN-TEC Model 712 USB Sound Card Interface | ||
+ | *100 Watt output power with the TEN-TEC Model 418 Linear Amplifier. | ||