This is an old revision of the document!
Titan Model 425 Linear Amplifier
Specifications
- Band Coverage: 1.8 - 2.0, 3.2 - 4.7, 6.5 - 8.5, 13.4 - 19.6, 17.6 - 23.0 MHz, With 10 meter modification, 17.6 - 26.5, 20.6 - 31 MHz.
- Input Power: 2000 watts, maximum.
- Power Output: 1300 watts SSB, 1000 watts CW, RTTY and SSTV 650 watts, 50% duty cycle.
- Drive Power: 100 watts for full rated output.
- Efficiency: 50 - 65%, depending on frequency and load impedance.
- Input/Output Impedances: 50 Ohms, unbalanced, SWR < 2:1.
- Distortion: -35 dB from 1 kw RF output level.
- Harmonics: -50 dB typical.
- CW Break-in: QSK capable, Relay switching.
- Tube Complement: Two Eimac 3-500Z.
- Power Amplifier Circuit: Class AB2, grounded grid.
- Plate Voltage: 3100 volts, no load. 2600 volts, full load.
- Cooling: Forced air with full chassis air flow.
- Metering: Dedicated plate current meter. Selectable multi-meter for plate voltage, grid current, forward or reflected power. Ten element LED bargraph display for peak power indication.
- Front Panel Status Indicators: Standby, operator, transmit.
- Primary Power: 220 - 250 VAC @ 15 A, 110 - 125 VAC @ 30 A, 50/60 Hz. For full power operation, 220 - 250 VAC strongly recommended.
- Circuit Protection: Primary line fuses. Plate transformer primary interlock and high voltage shorting bar.
- Front Panel Controls: Power on/off, standby/operate, control mode select (QSK - PTT/VOX), plate TUNE and LOAD, band switch, meter switch.
- Tune and Load Controls: 6:1 vernier drives with calibrated dial skirts.
- Construction: Aluminum chassis, front and rear panels, interior partitions and top and bottom covers.
- Size: HWD 8.25" x 15.25" x 18.5" (20.3 x 38.7 x 46.9 cm)
- Weight: 47 lbs (21.3 kg)