Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
280 [2007/02/13 19:44] n5na created |
280 [2007/05/21 00:41] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Power Supply Model 280 ====== | ====== Power Supply Model 280 ====== | ||
+ | {{280.jpg?150|}} | ||
+ | |||
===== Description ===== | ===== Description ===== | ||
- | Ideal for powering the CORSAIR Model [[560]]transceiver on either 115 or 230 VAC, 50-60 Hz. Easy to change for either primary voltage. Regulated output, over-voltage and over-current protected, and can be switched form transceiver or power supply. | + | Ideal for powering the CORSAIR Model [[560]] transceiver on either 115 or 230 VAC, 50-60 Hz. Easy to change for either primary voltage. Regulated output, over-voltage and over-current protected, and can be switched from transceiver or power supply. Same circuitry as the Model [[255]], but with dual primary and without the build-in speaker. |
+ | ===== Specifications ===== | ||
+ | ***Input Voltage:** 105 - 125 VAC, 50-60 Hz or 210 - 250 VAC, 50-60 Hz | ||
+ | ***Output:** 13.5 VDC +/- 0.5 VDC. | ||
+ | ***Regulation:** Better than 1% no load to full load at 117 VAC. | ||
+ | ***Output Current:** 18 amperes, full load; 20 amperes, maximum. | ||
+ | ***Ripple:** Less than 60 mV peak-to-peak at 18A at 117 VAC. | ||
+ | ***Circuit Breaker:** Electronic latching. Factory set at 20A. | ||
+ | ***Over-Voltage Protection:** Trips above 16V output. | ||
+ | ***Panel Meter:** 0 - 25 amperes. | ||
+ | ***Connections:** Attached 3' cable with four pin AMP MATE-N-LOC connector for high current and remote on/off switching. Two phono connectors for low current output. | ||
+ | ***Finish:** Dark painted front panel, dark textured top and sides. | ||
+ | ***Size:** HWD 5.5" x 7" x 12". | ||
+ | ***Wt:** 15 lbs. |