Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
280 [2007/04/19 02:47] n5na |
280 [2007/04/19 02:51] n5na |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| ===== Description ===== | ===== Description ===== | ||
| Ideal for powering the CORSAIR Model [[560]] transceiver on either 115 or 230 VAC, 50-60 Hz. Easy to change for either primary voltage. Regulated output, over-voltage and over-current protected, and can be switched from transceiver or power supply. Same circuitry as the Model [[255]], but with dual primary and without the build-in speaker. | Ideal for powering the CORSAIR Model [[560]] transceiver on either 115 or 230 VAC, 50-60 Hz. Easy to change for either primary voltage. Regulated output, over-voltage and over-current protected, and can be switched from transceiver or power supply. Same circuitry as the Model [[255]], but with dual primary and without the build-in speaker. | ||
| + | |||
| ===== Specifications ===== | ===== Specifications ===== | ||
| - | ***Input:** 105 - 125 VAC, 50-60 Hz or 210 - 250 VAC, 50-60 Hz | + | ***Input Voltage:** 105 - 125 VAC, 50-60 Hz or 210 - 250 VAC, 50-60 Hz |
| ***Output:** 13.5 VDC +/- 0.5 VDC. | ***Output:** 13.5 VDC +/- 0.5 VDC. | ||
| ***Regulation:** Better than 1% no load to full load at 117 VAC. | ***Regulation:** Better than 1% no load to full load at 117 VAC. | ||
| - | ***Output Current:** 20 ampere, full load. | + | ***Output Current:** 18 amperes, full load; 20 amperes, maximum. |
| ***Ripple:** Less than 60 mV peak-to-peak at 18A at 117 VAC. | ***Ripple:** Less than 60 mV peak-to-peak at 18A at 117 VAC. | ||
| ***Circuit Breaker:** Electronic latching. Factory set at 20A. | ***Circuit Breaker:** Electronic latching. Factory set at 20A. | ||
| ***Over-Voltage Protection:** Trips above 16V output. | ***Over-Voltage Protection:** Trips above 16V output. | ||
| - | ***Connectors:** One 4-pin AMP MATE-N-LOC, two phono jacks for low current. | + | ***Panel Meter:** 0 - 25 amperes. |
| + | ***Connections:** Attached 3' cable with four pin AMP MATE-N-LOC connector for high current and remote on/off switching. Two phono connectors for low current output. | ||
| + | ***Finish:** Dark painted front panel, dark textured top and sides. | ||
| ***Size:** HWD 5.5" x 7" x 12". | ***Size:** HWD 5.5" x 7" x 12". | ||
| ***Wt:** 15 lbs. | ***Wt:** 15 lbs. | ||
