Differences
This shows you the differences between two versions of the page.
|
255 [2007/04/18 01:36] n5na |
255 [2007/05/21 00:41] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Power Supply / Speaker Model 255 ====== | ||
| - | {{255.jpg?150|}} | ||
| - | ===== Description ===== | ||
| - | *Dual primary (115/230 Vac, 50-60 Hz) supply plus 3" x 5" front-facing speaker. | ||
| - | *13.5 Vdc (+0.5V) output, regulated to better than 1%, no-load to full-load, at 117 Vac, with output current of 18A, full load, 20A max., and less than 60 mV peak-peak ripple. | ||
| - | *Over-voltage and over-current protection (16V and 20A). | ||
| - | *25A panel meter, power switch, and phone jack. | ||
| - | *5.875"h x 8.25"w x 12"d, 11 lbs. | ||
| - | *Black and bronze finish. | ||
| - | |||
| - | ===== Specifications ===== | ||
| - | |||
| - | ***Input Voltage:** 105 - 125 VAC, 50-60 Hz | ||
| - | ***Output Voltage:** 13.5 VDC +/- 0.5 V | ||
| - | ***Regulation:** Better than 1% no load to full load @ 117 VAC | ||
| - | ***Output Current:** Zero to 18 amperes, full load, 20 amperes maximum. | ||
| - | ***Ripple:** Less than 60 mV p-p @ 18 A and 117 VAC | ||
| - | ***Circuit Breaker:** Electronic latching. Factory set at 20A. | ||
| - | ***Over-voltage Protection:** Trips above 16V output. | ||
| - | ***Panel Meter:** 0 - 25 amperes. | ||
| - | ***Speaker:** 3" x 5" oval, 8 ohm, ceramic magnet. | ||
| - | ***Output Connectors:** Attached 3' cable with four pin AMP MATE-N-LOK connector for high current and remote on/off switching. Two phono connectors for low current. Attached 3' cable with 1/4" phone plug for speaker input. Front panel PHONES jack. | ||
| - | ***Finish:** Satin etched and extruded panel trim, dark painted front panel, dark textured top and bottom. | ||
| - | ***Size:** HWD 5-7/8" x 8-1/4" x 12". | ||
| - | ***Weight:** 16 lbs. | ||
