Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
255 [2007/04/12 18:52] n5na |
255 [2007/04/18 01:40] n5na |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ===== Description ===== | ===== Description ===== | ||
| - | *Dual primary (115/230 Vac, 50-60 Hz) supply plus 3" x 5" front-facing speaker. | + | Designed to match the OMNI Models 545 and 546 transceivers. Deluxe power supply with metered output, high current, and built-in speaker. Integral overload current protection circuit is activated when more than 20 amperes are drawn from the supply. The electronic circuit breaker is latching type, requiring manual reset. Over-voltage protection is integral. Primary power is switched from the front panel or remotely from the transceiver. |
| - | *13.5 Vdc (+0.5V) output, regulated to better than 1%, no-load to full-load, at 117 Vac, with output current of 18A, full load, 20A max., and less than 60 mV peak-peak ripple. | + | |
| - | *Over-voltage and over-current protection (16V and 20A). | + | ===== Specifications ===== |
| - | *25A panel meter, power switch, and phone jack. | + | |
| - | *5.875"h x 8.25"w x 12"d, 11 lbs. | + | ***Input Voltage:** 105 - 125 VAC, 50-60 Hz |
| - | *Black and bronze finish. | + | ***Output Voltage:** 13.5 VDC +/- 0.5 V |
| + | ***Regulation:** Better than 1% no load to full load @ 117 VAC | ||
| + | ***Output Current:** Zero to 18 amperes, full load, 20 amperes maximum. | ||
| + | ***Ripple:** Less than 60 mV p-p @ 18 A and 117 VAC | ||
| + | ***Circuit Breaker:** Electronic latching. Factory set at 20A. | ||
| + | ***Over-voltage Protection:** Trips above 16V output. | ||
| + | ***Panel Meter:** 0 - 25 amperes. | ||
| + | ***Speaker:** 3" x 5" oval, 8 ohm, ceramic magnet. | ||
| + | ***Output Connectors:** Attached 3' cable with four pin AMP MATE-N-LOK connector for high current and remote on/off switching. Two phono connectors for low current. Attached 3' cable with 1/4" phone plug for speaker input. Front panel PHONES jack. | ||
| + | ***Finish:** Satin etched and extruded panel trim, dark painted front panel, dark textured top and bottom. | ||
| + | ***Size:** HWD 5-7/8" x 8-1/4" x 12". | ||
| + | ***Weight:** 16 lbs. | ||
