Differences
This shows you the differences between two versions of the page.
|
252g [2007/04/12 18:52] n5na |
252g [2007/05/21 00:41] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Power Supply Model 252G ====== | ||
| - | {{252g.jpg?150|}} | ||
| - | ===== Description ===== | ||
| - | The Model 252G Power Supply will deliver up to 18 amperes at approximately 13 VDC, regulated, from a 117 VAC 50-60 Hz source. An electronic latching circuit breaker shuts down the output voltage when a current in excess of 20 amperes is drawn from the supply. Reset is accomplished by cycling the POWER switch. Two indicator lamps monitor the LINE and OUTPUT voltages. The primary circuit is fused with a slo-blo fuse. The output voltage is available through a six pin Jones connector and a phono gype jack for low current applications. Two of the six Jones pins are used for remote power on-off switching, if desired. Will accept the Model [[207]] ammeter. | ||
| - | |||
| - | ===== Specifications ===== | ||
| - | |||
| - | ***Input Voltage:** 117 VAC, 50-60 Hz. | ||
| - | ***Output Voltage:** 13 VDC, +/- 0.5 V, regulated. | ||
| - | ***Construction:** Aluminum with molded plastic side panels. | ||
| - | ***Output Connectors:** One 6 pin Jones type, one phono jack for low current, one phono jack for Model [[207]] Ammeter. | ||
| - | ***Output Current:** 18 amperes continuous, full load. 20 amperes, maximum. | ||
| - | ***Circuit Breaker:** Electronic latching. Factory set to trip at 20 A. | ||
| - | ***Ripple:** Less than 60 mV, peak-to-peak @ 18 A and 117 VAC. | ||
| - | ***Size:** HWD 4.5" x 8.25" x 13" | ||
| - | ***Weight:** 14.5 lbs. | ||
