Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
1254pbigelow [2007/03/27 16:49] n5na |
1254pbigelow [2007/03/29 09:36] n5na |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== 1254 Review by Paul Bigelow ====== | ====== 1254 Review by Paul Bigelow ====== | ||
| - | **From the Ten Tec Reflector April 1, 1998** | + | **From the Ten-Tec Reflector April 1, 1998** |
| I have built the 1254 receiver and it is a nice little unit. A real joy to build, use and tune around. I haven't had this much fun in ages! | I have built the 1254 receiver and it is a nice little unit. A real joy to build, use and tune around. I haven't had this much fun in ages! | ||
| Line 24: | Line 24: | ||
| * Reduced sensitivity on the lower half of the AM broadcast band. | * Reduced sensitivity on the lower half of the AM broadcast band. | ||
| *Remedy: Put a jumper across R72, eliminating that input filter. | *Remedy: Put a jumper across R72, eliminating that input filter. | ||
| - | * FM intermod from strong FM stations. Just add 90 (2* 1st IF) to the received frequency | + | * FM intermod from strong FM stations. Just add 90 (2* 1st IF) to the received frequency to detetmine offending frequency. |
| - | to detetmine offending frequency. | + | |
| *Remedy: Have tried with some success (but none totally satisfactory): | *Remedy: Have tried with some success (but none totally satisfactory): | ||
| - | * Snap-on RF choke on power cable | + | * Snap-on RF choke on power cable |
| - | * Soldered on a shield on trace side of the board around the 1st Mixer section. | + | * Soldered on a shield on trace side of the board around the 1st Mixer section. |
| - | * Incorporated FM trap (from Radio Shack) in the antenna lead. | + | * Incorporated FM trap (from Radio Shack) in the antenna lead. |
| * The rotary Encoder loosens up with use causing the frequencies to jump around (sometimes) when tuning from one step to another. | * The rotary Encoder loosens up with use causing the frequencies to jump around (sometimes) when tuning from one step to another. | ||
| * Possible Remedy (have not tried yet): Sandwiching a large, black, felt washer between the tuning knob and the tuning knob recess to reduce play. | * Possible Remedy (have not tried yet): Sandwiching a large, black, felt washer between the tuning knob and the tuning knob recess to reduce play. | ||
| Line 36: | Line 35: | ||
| * Deafening thump upon turning on the 1254 when using headphones. REALLY LOUD. | * Deafening thump upon turning on the 1254 when using headphones. REALLY LOUD. | ||
| * Remedy: None yet although I suspect a large capactior may resolve this one. | * Remedy: None yet although I suspect a large capactior may resolve this one. | ||
| - | * A little bit of "thumping" due to slow synthesizer lock. Not too bad, really, considering | + | * A little bit of "thumping" due to slow synthesizer lock. Not too bad, really, considering the price. |
| - | the price. | + | |
| Paul | Paul | ||
