Titan II Model 416

ARRL (Must be an ARRL member and logged in to view.)

Band Coverage: 160, 80, 40, 30, 20, 17 and 15 meters (12 and 10 meters for authorized users)

Power Output: 1500 watts continuous in SSB, CW, AMTOR/PACTOR (50 % duty cycle modes). 1500 watts RTTY/SSTV for up to 30 minutes (100% duty cycle modes). 1000 watts continuous key down.

Bold TextDrive Power: 80 watts typical for 1500 watts output.

Tube: Svetlana 4CX1600B ceramic tetrode.

Plate Voltage Supply: Step-start inrush protected. 3000 VDC at no load, 2700 VDC at full load. 6 amp; 1000 PIV matched diodes in full wave bridge. Filtered by 9 each 450 VDC 220 uF electrolytic capacitors. 10 ohm arc absorption resistor.

Efficiency: Up to 65% depending on band, frequency, line voltage, and load impedance.

Input/Output impedances: 50 ohms unbalanced with VSWR <2:1.

Harmonic Suppression: Meets or exceeds FCC requirements.

Full Break-in: Built-in with T/R switching of less than 7 milliseconds.

Protective Circuits: A) Screen grid current regulation, over voltage protection and metal-oxide varistor arc-over protection. LED overdrive indication. B) Control grid current regulation, over-current limiting, LED overdrive indication. C) Plate current overdrive trip at 1.6A, series resistor for arc absorption.

Primary Power: 240 VAC@20 amps, 50/60 Hz.

Line Protection: Primary line fuses, chassis interlock, and step-start inrush protection.

Cooling: Duct forced air, vertical exhaust, centrifugal blower.

Metering: Plate current, screen grid current, plate voltage, forward and reverse power. Peak foward power indicated on LED bargraph.

Front Panel Controls: TUNE and LOAD controls, band switch, standby/operate, QSK/PTT, meter switch for screen grid current, plate voltage, forward or reverse power, power on/off.

Construction: .125" aluminum tank and transformer chassis, .062" aluminum control chassis and covers.

Size: HWD 8.2" x 17" x 19"

Weight: 81 lbs. (36.8 kg).