====== Paragon MARS / CAP / 60m Mod ======
**From the Ten-Tec Reflector December 8, 2004**

On my two Paragon's, the MARS/CAP/60M mod is accomplished by cutting/unsoldering the jumper wire on the logic board (Labeled "HAM")
and resetting the processor.  The jumper is located directly below the 9 volt memory battery.

NOW, if someone can tell me what/where the mod is on the Paragon II, I would appreciate it VERY much.

Jim/Ke3nK

**Added 6/19/2007 - From the PARAGON Manual:**
The RESET switch is accessible through a hole located on the right side of the Paragon.  This switch is connected to the microprocessor and will cause a system reset when pressed.  NOTE: Pressing the RESET switch will clear ALL MEMORIES and will also clear the clock and date information.

----
**December 9, 2004**

Same place. Mine was a yellow wire loop labeled HAM and its about 1/3 from the back of the radio on the right side. Not sure what the board is, but it works well.

73 Rick\\ 
N4ASX