Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
280 [2007/02/13 19:44] n5na created |
280 [2007/04/19 02:47] n5na |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Power Supply Model 280 ====== | ====== Power Supply Model 280 ====== | ||
| + | {{280.jpg?150|}} | ||
| + | |||
| ===== Description ===== | ===== Description ===== | ||
| - | Ideal for powering the CORSAIR Model [[560]]transceiver on either 115 or 230 VAC, 50-60 Hz. Easy to change for either primary voltage. Regulated output, over-voltage and over-current protected, and can be switched form transceiver or power supply. | + | Ideal for powering the CORSAIR Model [[560]] transceiver on either 115 or 230 VAC, 50-60 Hz. Easy to change for either primary voltage. Regulated output, over-voltage and over-current protected, and can be switched from transceiver or power supply. Same circuitry as the Model [[255]], but with dual primary and without the build-in speaker. |
| + | ===== Specifications ===== | ||
| + | ***Input:** 105 - 125 VAC, 50-60 Hz or 210 - 250 VAC, 50-60 Hz | ||
| + | ***Output:** 13.5 VDC +/- 0.5 VDC. | ||
| + | ***Regulation:** Better than 1% no load to full load at 117 VAC. | ||
| + | ***Output Current:** 20 ampere, full load. | ||
| + | ***Ripple:** Less than 60 mV peak-to-peak at 18A at 117 VAC. | ||
| + | ***Circuit Breaker:** Electronic latching. Factory set at 20A. | ||
| + | ***Over-Voltage Protection:** Trips above 16V output. | ||
| + | ***Connectors:** One 4-pin AMP MATE-N-LOC, two phono jacks for low current. | ||
| + | ***Size:** HWD 5.5" x 7" x 12". | ||
| + | ***Wt:** 15 lbs. | ||
