This is an old revision of the document!


Eagle Model 599

Eagle Rear

This is a current production model. Please visit Ten-Tec, Inc. for more information.

Description

HF plus 6 meters transceiver along with general coverage receive. Dual VFO’s with SPLIT mode and 100 memories, passband tuning, adjustable AGC, variable CW offset, RIT, built in CTCSS tones for 6 meter FM and QSK.

Specifications

General

Microphone Connector: 8-Pin Headphone Jack: 1/4" Stereo, accepts mono or stereo plug. External CW Key Jack: 1/8 " Stereo External Speaker Jack: 1/8" Mono Aux DC Output Connector: RCA x2 Frequency Range TX: Ham Bands Only (160-6M) ACC Din Connector: 8 PIN DIN Connector - Line In, Line Out, Aux PTT, Ext Key, Clock/Data/Enable, Ground DC Power Connector: Power Pole Fuse: Automotive Blade Style Fuse, 25 Amp 32V Frequency Range RX: 500 kHz � 30 MHz and 50 � 54MHz. Specifications apply within Amateur Radio bands only. Tuning Step Size: 1, 10, 100, 1000, 10000 Frequency Stability: Maximum +/- 0.5 PPM over operating temperature Antenna Impedance: 50 ohms nominal. Antenna Connectors: 1 x SO-239 transceive Modes: USB, LSB, CW, AM (optional), FM (optional) Memories: 100 Frequency Accuracy: +-5Hz @25C, 1 Hz tuning resolution Supply Voltage Range: 13.8V +/-15% Operating Temp. Range: 0-50 degrees Celsius Dimensions (H x W x D): 2.9" x 8.5" x 10.25" (excluding knobs and connectors) Weight: 7.25 lbs with all options Construction: Molded plastic front panel, aluminum chassis and texture painted steel covers PC Control Port: USB (using CCS USB to UART Driver) Display: Custom FSTN monochrome LCD Display Backlight: 256 colors X 16 intensity levels

Receiver

SSB Sensitivity: Better than 0.7uV, 2.4khz, 10dB SINAD, preamp off AM Sensitivity: Better than 4uV, 30% Mod, 6kHz BW, 10dB SINAD, preamp off FM Sensitivity: Better than 2.2uV, 5kHz Dev, 16kHz BW, 10dB SINAD, preamp off Selectivity IF1: 2.4khz standard, 9.0015 MHz, 2 options Selectivity IF2: 30 KHz Lowpass filter Selectivity, DSP IF: 127 built-in DSP filters from 100-15000 Hz BW Third Order Intercept Point (IP3): Typical 20dBm @ 20kHz tone separation/2.4 kHz roofing filter, 17dBm @ 2kHz separation/600Hz roofing filter, S5 method, preamp off IMD3 Dynamic Range: Typical 97dB/20kHz, 95dB/2kHz, 500Hz BW, calculated 2/3(IP3-Noise Floor), preamp off Blocking Dynamic Range: 138dB/20kHz, 127dB/2kHz, 500 Hz BW, RF gain @ 12 o'clock, preamp off LO Phase Noise: Typical -132dBc/Hz @ 20kHz, -121dBc/Hz @ 2kHz Noise Floor: Typical -132dBm/500Hz BW/preamp on, -126dBm preamp off IF Frequencies: 1st:9.0015 MHz, 2nd:22.5 kHz, 3rd:0Hz (DSP) IF Rejection: Better than 70dB 1st IF Image Rejection: Better than 90dB/HF bands, 70dB/6M 2nd IF Image Rejection: Better than 73dB Other Spurious Response Rejection: Rejection:>80dB Other Spurious Response Rejection: Birdies: Typically less than -100dBm equivalent (no more than 5 birdies greater than -100dBm equivalent) Pass Band Tuning: +/- 2.1kHz, 5Hz steps. Small dead zone for centering Attenuator: 10 db PreAmp: Nominal 12 db Audio Output: 2W into 4 ohms, <3% THD RIT range: +/- 8.2 kHz RIT Step size: 10Hz S-Meter Reference: S9 = 50 uV RMS TX>RX Recovery Time: < 20 ms RX Headphone Output: Designed for 16-32 ohms impedance headphones. Usable at 8 ohms AUX Audio Output: 500 mv Auto Notch: IF DSP, multi-tone RX Noise Reduction: IF DSP, adjustable Noise Blanker: Optional daughter board, 2 levels of blanking RX Current Drain: 1.25 Amps General Coverage Receive: degraded specs outside ham bands

Transmitter

RF Power Output: Adjustable, 5-100 W, +/- 1 dB CW & SSB Duty Cycle: continuous service @ 100W AM,FM,AFSK,PSK Duty Cycle: continuous service @100W, 50% duty cycle (Tx/Rx) CW/SSB TX Bandwidth: 2.4kHz Filter AM TX Bandwidth: 6k FM TX Bandwidth: 15kHz Optional Filter Microphone Input Impedance:>10 k-ohms at 1 kHz Microphone Sensitivity: 1 mV RMS for full power output, internal gain adjustment, 9v dc power for electret elements FM Deviation: +/- 5 kHz peak nominal AUX Level Input: variable, 200mV nominal SSB Carrier Supression:> 70 dB Unwanted Sideband Suppression:> 60 dB at 1 kHz Harmonic & Spurious Outputs: ←50dBc @100 W <30MHz; -60dB>30MHz; -43 dB <5 W T/R Switching: PTT or VOX on SSB, AM, FM, QSK on CW CW Keyer Type: Internal Curtis Mode B CW Rise and Fall Times: 5ms CW Offset: adjustable CW Keyer Speed: 5-60 WPM, adjustable weighting Current Drain: transmit 20 amps typ. Third Order Intermod: Better than 25dB below peak SSB Generation: DSP Generated No. of DSP generated TX bandwidths: 3 built-in DSP filters - automatically selected - standard = 2.4Khz for SSB/CW; optional = 6Khz for AM, 12Khz for FM

Antenna Tuner

Type: Reversible L-network Matching frequency range: 160 to 10 Meters, no Six Meters Matching impedance range: 10:1 SWR typical

Options

Filters: 2.4K standard, optional = 300, 600, 1.8k, 6k, 15k Noise Blanker: daughter board module Auto Tuner: daughter board module


QR Code
QR Code 599 (generated for current page)