Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
588split [2010/06/19 19:03]
ab9m
588split [2010/06/20 02:53] (current)
ab9m
Line 10: Line 10:
  
 With this configuration you can push the A/B button to toggle between listening to the DX (VFO A) with narrow BW and the pile (VFO B) with wide BW. An advantage to this configuration is that since the VFO on the DX QRG is in CW, it will NOT transmit SSB on the DX's freq. With this configuration you can push the A/B button to toggle between listening to the DX (VFO A) with narrow BW and the pile (VFO B) with wide BW. An advantage to this configuration is that since the VFO on the DX QRG is in CW, it will NOT transmit SSB on the DX's freq.
 +
 +While setting wide and narrow Band Width / mode splits for pile-up busting, I discovered its easier than I previously posted. You do NOT need to use different band registers for CW and SSB Dxing.
 + 
 +I use the "​D"​ register for each band. Set the frequency inside the band. Push "​A=B";​ push "​SPL";​ Push "​Mode"​ then the correct SSB for the band (LSB 160, 80, 40; USB 20, 15, 10).  Set the BW to 500.
 + 
 +Push "​A/​B";​ Push "​Mode"​ then the CW mode corresponding to the SSB set above (to keep the signal with the same pass band relationship) LCW for LSB or UCW for SSB; Set the BW to 2400. 
 + 
 +Do the above procedure for each band. Once set up, it’s just a matter of going to the desired band and the "​split"​ register (D in my case) and the cross mode BW splits are configured.
 + 
 +For CW DX, push the "​A/​B" ​ until the Mode is USB or LSB, tune to the DX, set the BW to a comfortable narrow value, push "​A/​B";​ UCW or LCW is displayed, tune to the pile, set the BW to a wide value. Push "​A/​B"​ to RX on the DX / TX in the pile or Push "​A/​B"​ to listen to the pile and NOT transmit on the DX.
 + 
 +For SSB DX, push the "​A/​B" ​ until the Mode is UCW or LCW, tune to the DX, set the BW to a comfortable narrow value, push "​A/​B";​ USB or LSB is displayed, tune to the pile, set the BW to a wide value. Push "​A/​B"​ to RX on the DX / TX in the pile or Push "​A/​B"​ to listen to the pile and NOT transmit on the DX.
 + 
 + 
  
 CSM(retired) Gary Huber - AB9M\\ CSM(retired) Gary Huber - AB9M\\

QR Code
QR Code 588split (generated for current page)