Differences
This shows you the differences between two versions of the page.
565lpf_remove [2015/07/08 18:02] n1eu created |
565lpf_remove [2015/07/08 18:03] n1eu |
||
---|---|---|---|
Line 9: | Line 9: | ||
4)Unplug J13 and J17, and remove the 3 screws at top the edge of the board. | 4)Unplug J13 and J17, and remove the 3 screws at top the edge of the board. | ||
- | 5)Turn the unit over and unplug J8 and J14, and remove the 3 screws at the bottomedge of the | + | 5)Turn the unit over and unplug J8 and J14, and remove the 3 screws at the bottom edge of the board. |
- | board. | + | |
- | 6)Cut the ty-wrap holding the J14 harness and the J17 coax. Also remove thenearby double- | + | 6)Cut the tie-wrap holding the J14 harness and the J17 coax. Also remove thenearby double-sided tape. |
- | sided tape. | + | |
- | 7)With the rig still upside down, remove the board far enough to unplug J12 andthen | + | 7)With the rig still upside down, remove the board far enough to unplug J12 and then J7, J9, and J11. |
- | J7, J9, and J11. | + | |
Note:To work on the board (i.e. Replace relays, etc.) the white coaxial cables can be left in place. | Note:To work on the board (i.e. Replace relays, etc.) the white coaxial cables can be left in place. |