Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
564txenout [2011/11/15 13:15]
n1eu
564txenout [2011/11/20 12:21] (current)
n1eu
Line 1: Line 1:
-Although ​the Omni 6+ can be used with the Acom 2000A by enabling the relay in the menu and using the relay output, it's preferable to perform a simple mod to allow the TX EN/​OUT ​qsk loop to fully function.+====== Using the Omni 6 TX EN/​OUT ​QSK Loop with Acom Amplifiers ======
  
-{{:​txenoutmod.jpg?​200|}}+**UPDATE:​** ​ I implemented the change below and I am still getting "​Detected RF Power at Wrong Time" errors in SSB about 10% of the time (not CW).  I tried all methods of connecting the Omni 6+ to the Acom 2000A and couldn'​t get around these occasional errors during SSB xmsn.  I am waiting for a solution from Acom, but I'm not sure if  the Acom and Omni 6+ is a good match. ​ My Omni 6+ runs fine with my Alpha 99. 
 + 
 +---- 
 + 
 +Although the Omni 6+ can be used with the Acom 2000A by enabling the relay in the menu and using the relay output, it's preferable to perform a simple mod to the Omni 6 Control Board that allows the TX EN/OUT qsk loop to fully function. ​ Remove the Control Board from the chassis, unsolder/​lift one end of R26 as shown, and add the circuitry in blue below. ​ The MOSFET is available from Digikey as part number VN10LP-ND 
 + 
 +{{:​txenoutmod.jpg?​|}} 
 + 
 +//(based on info provided by Acom Bulgaria for the Paragon and adapted for Omni 6 by N1EU - component reference designators were corrected)//​

QR Code
QR Code 564txenout (generated for current page)