Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
564_40m [2015/08/28 12:13]
n1eu
564_40m [2015/08/28 13:29]
n1eu
Line 12: Line 12:
 And the list goes on and on where missing bands have been concerned. Each And the list goes on and on where missing bands have been concerned. Each
 of these problems was a PIN Diode. In your case it is D12 on the OSC-Low of these problems was a PIN Diode. In your case it is D12 on the OSC-Low
-Mixer Board. If you look at page 6-14 of the Manual or page 52 of 132 of +Mixer Board. If you look at page 6-14 of the Manualor page 52 of 132 of 
-the .PDF on your computer. You will see Connector 82( osc-low mixer board +the .PDF on your computer, you will see Connector 82 ( osc-low mixer board)The band switching is done by applying a positive voltage to the proper
-) The band switching is done by applying a positive voltage to the proper+
 diode to activate the proper crystal.\\ ​ diode to activate the proper crystal.\\ ​
 \\ \\

QR Code
QR Code 564_40m (generated for current page)