This is an old revision of the document!


Omni V Speaker Pop Mod

From Ten-Tec Reflector May 2, 1998

Cure for first dot on cw speaker pop or first microphone ptt pop in speaker.

Add a 470k resistor to U10 on the IF/AF board between pin 5 and ground is the factory mod. I did the following on mine.

Locate R78, 330k beside U10. Solder a 100k resistor from the lead of R78, nearest the front panel, to ground. The 100k seemed to be more effective on mine.

Soldering to the lead of R78 is more easily done than soldering to U10's lead and can easily be done from the top without removing the board.

Steve Ellington N4LQ


QR Code
QR Code 562pop (generated for current page)