Differences
This shows you the differences between two versions of the page.
546caudio [2007/05/21 00:42] |
546caudio [2007/05/21 00:42] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Omni Series C Audio Mod ====== | ||
+ | **From the Ten-Tec Reflector September 19, 1999** | ||
+ | Here is a simple mod for improved audio on the Omni C. I have not tested it on other Omni series such as A, B, D etc. but most likely it would have the same effect. It gives a boost to voice frequencies and a slight peak around 600-700hz for cw. All signals seem to be much easier to copy with the now brilliant sounding audio. | ||
+ | |||
+ | Parts needed.........1ea. 1 meg resistor | ||
+ | |||
+ | - Remove bottom cover of rig. | ||
+ | - Locate the audio-sidetone board. This is the one with the sidetone pots. There is no need to remove the board. | ||
+ | - Solder the resistor between pin 2 of IC-1 (LM-380) and AF-Output. Instead of soldering directly to pin 2 of IC-1, you may want to solder to R8's (10K) lead which connects to pin 2 and the other end to C11's negative lead. | ||
+ | - I suggest sliding some insulation over the 1 meg resistor's leads to prevent shorting. | ||
+ | - Replace the bottom cover and enjoy. | ||
+ | |||
+ | 73 | ||
+ | Steve N4LQ |