Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
280 [2007/04/18 22:47]
n5na
280 [2007/05/20 20:41] (current)
Line 4: Line 4:
 ===== Description ===== ===== Description =====
 Ideal for powering the CORSAIR Model [[560]] transceiver on either 115 or 230 VAC, 50-60 Hz.  Easy to change for either primary voltage. ​ Regulated output, over-voltage and over-current protected, and can be switched from transceiver or power supply. ​ Same circuitry as the Model [[255]], but with dual primary and without the build-in speaker. Ideal for powering the CORSAIR Model [[560]] transceiver on either 115 or 230 VAC, 50-60 Hz.  Easy to change for either primary voltage. ​ Regulated output, over-voltage and over-current protected, and can be switched from transceiver or power supply. ​ Same circuitry as the Model [[255]], but with dual primary and without the build-in speaker.
 +
  
 ===== Specifications ===== ===== Specifications =====
  
-  ***Input:** 105 - 125 VAC, 50-60 Hz or 210 - 250 VAC, 50-60 Hz+  ***Input ​Voltage:** 105 - 125 VAC, 50-60 Hz or 210 - 250 VAC, 50-60 Hz
   ***Output:​** 13.5 VDC +/- 0.5 VDC.   ***Output:​** 13.5 VDC +/- 0.5 VDC.
   ***Regulation:​** Better than 1% no load to full load at 117 VAC.   ***Regulation:​** Better than 1% no load to full load at 117 VAC.
-  ***Output Current:​** ​20 ampere, full load.+  ***Output Current:​** ​18 amperes, full load; 20 amperes, maximum.
   ***Ripple:​** Less than 60 mV peak-to-peak at 18A at 117 VAC.   ***Ripple:​** Less than 60 mV peak-to-peak at 18A at 117 VAC.
   ***Circuit Breaker:** Electronic latching. ​ Factory set at 20A.   ***Circuit Breaker:** Electronic latching. ​ Factory set at 20A.
   ***Over-Voltage Protection:​** Trips above 16V output.   ***Over-Voltage Protection:​** Trips above 16V output.
-  ***Connectors:** One 4-pin AMP MATE-N-LOC, two phono jacks for low current.+  ***Panel Meter:** 25 amperes. 
 +  ***Connections:​** Attached 3' cable with four pin AMP MATE-N-LOC ​connector for high current and remote on/off switching. Two phono connectors ​for low current ​output. 
 +  ***Finish:​** Dark painted front  panel, dark textured top and sides.
   ***Size:** HWD 5.5" x 7" x 12".   ***Size:** HWD 5.5" x 7" x 12".
   ***Wt:** 15 lbs.   ***Wt:** 15 lbs.

QR Code
QR Code 280 (generated for current page)